MC9RS08KA1 FREESCALE [Freescale Semiconductor, Inc], MC9RS08KA1 Datasheet - Page 101

• Manufacturer Part Number: MC9RS08KA1
• Description: RS08 Microcontrollers
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Active BDM:
The following describes the actual bit-time requirements for a host to guarantee logic 1 or 0 bit
transmission without the target timing out or interpreting the bit as a SYNC command:
12.4
The BDC contains two non-CPU accessible registers:
These registers are accessed with dedicated serial BDC commands and are not located in the memory
space of the target MCU (so they do not have addresses and cannot be accessed by user programs).
Some of the bits in the BDCSCR have write limitations; otherwise, these registers may be read or written
at any time. For example, the ENBDM control bit may not be written while the MCU is in active
background mode. This prevents the ambiguous condition of the control bit forbidding active background
mode while the MCU is already in active background mode. Also, the status bits (BDMACT, WS, and
WSF) are read-only status indicators and can never be written by the WRITE_CONTROL serial BDC
command.
12.4.1
This register can be read or written by serial BDC commands (READ_STATUS and WRITE_CONTROL)
but is not accessible to user programs because it is not located in the normal memory map of the MCU.
Freescale Semiconductor
Reset in
Normal
•
•
•
•
•
Reset
W
To send a logic 0, BKGD must be kept low for a minimum of 12 BDC cycles and up to 511 BDC
cycles except for the first bit of a command sequence, which will be detected as a SYNC request.
To send a logic 1, BKGD must be held low for at least four BDC cycles, be released by the eighth
cycle, and be held high until at least the sixteenth BDC cycle.
Subsequent bits must occur within 512 BDC cycles of the last bit sent.
The BDC status and control register (BDCSCR) is an 8-bit register containing control and status
bits for the background debug controller.
The BDC breakpoint register (BDCBKPT) holds a 16-bit breakpoint match address.
R
BDC Registers and Control Bits
BDC Status and Control Register (BDCSCR)
ENBDM
0
1
7
= Unimplemented or Reserved
BDMACT
Figure 12-6. BDC Status and Control Register (BDCSCR)
0
1
6
MC9RS08KA2 Series Data Sheet, Rev. 2
BKPTEN
0
0
5
FTS
4
0
0
0
0
0
3
WS
0
0
2
Chapter 12 Development Support
WSF
0
0
1
0
0
0
0
101