SAH-C515 SIEMENS [Siemens Semiconductor Group], SAH-C515 Datasheet - Page 50

• Manufacturer Part Number: SAH-C515
• Description: 8-Bit CMOS Microcontroller
• Manufacturer: SIEMENS [Siemens Semiconductor Group]

6.1.2.3
As shown in figure 6-3 and below in figure 6-5, the output drivers of ports 0 and 2 can be switched
to an internal address or address/data bus for use in external memory accesses. In this application
they cannot be used as general purpose I/O, even if not all address lines are used externally. The
switching is done by an internal control signal dependent on the input level at the EA pin and/or the
contents of the program counter. If the ports are configured as an address/data bus, the port latches
are disconnected from the driver circuit. During this time, the P0/P2 SFR remains unchanged. Being
an address/data bus, port 0 uses a pullup FET as shown in figure 6-3. When a 16-bit address is
used, port 2 uses the additional strong pullups p1 (figure 6-6) to emit 1’s for the entire external
memory cycle instead of the weak ones (p2 and p3) used during normal port activity.
Figure 6-5
Port 2 Circuitry
If no external bus cycles are generated using data or code memory accesses, port 0 can be used
for I/O functions.
Semiconductor Group
Port 2 Circuitry
Latch
Write to
Latch
Read
Pin
Read
Int. Bus
D
CLK
Latch
Bit
Q
Q
6-7
On-Chip Peripheral Components
MUX
Addr.
Control
=1
Arrangement
Internal
Pull Up
V
CC
MCS03228
Port
Pin
C515