EVAL-AD7324CB AD [Analog Devices], EVAL-AD7324CB Datasheet - Page 24

• Manufacturer Part Number: EVAL-AD7324CB
• Description: 4-Channel, Software-Selectable, True Bipolar Input, 12-Bit Plus Sign ADC
• Manufacturer: AD [Analog Devices]

AD7324
Table 11. Power Mode Selection
PM1
1
1
0
0
Table 12. Sequencer Selection
Seq1
0
0
1
1
PM0
1
0
1
0
Seq2
0
1
0
1
Description
Full Shutdown Mode. In this mode, all internal circuitry on the AD7324 is powered down. Information in the control register
is retained when the AD7324 is in full shutdown mode.
Autoshutdown Mode. The AD7324 enters autoshutdown on the 15
All internal circuitry is powered down in autoshutdown.
Autostandby Mode. In this mode, all internal circuitry is powered down excluding the internal reference. The AD7324 enters
autostandby mode on the 15
Normal Mode. All internal circuitry is powered up at all times.
Sequence Type
The channel sequencer is not used. The analog channel, selected by programming the ADD1 bit and ADD0 bit in the
control register, selects the next channel for conversion.
Uses sequence of channels that were previously programmed in the sequence register for conversion. The AD7324 starts
converting on the lowest channel in the sequence. The channels are converted in ascending order. If uninterrupted, the
AD7324 keeps converting the sequence. The range for each channel defaults to the range previously written into the
range register.
Used in conjunction with the channel address bits in the control register. This allows continuous conversions on a
consecutive sequence of channels, from Channel 0 up to and including a final channel selected by the channel address bits
in the control register. The range for each channel defaults to the range previously written into the range register.
The channel sequencer is not used. The analog channel, selected by programming the ADD1 bit and ADD0 bit in the
control register, selects the next channel for conversion.
th
SCLK rising edge after the control register is updated.
Rev. 0 | Page 24 of 36
th
SCLK rising edge when the control register is updated.