73K224L-28IH TDK [TDK Electronics], 73K224L-28IH Datasheet - Page 3

• Manufacturer Part Number: 73K224L-28IH
• Description: V.22bis/V.22/V.21/ Bell 212A/Bell 103 Single-Chip Modem
• Manufacturer: TDK [TDK Electronics]

synchronous operation as selected. Received data is
processed in a similar fashion except that the rate
converter now acts to reinsert any deleted stop bits
and output data to the terminal at no greater than the
bit rate plus 1%. An incoming break signal (low
through two characters) will be passed through without
incorrectly inserting a stop bit.
The SYNC/ASYNC converter also has an extended
Overspeed mode which allows selection of an output
overspeed range of either +1% or +2.3%. In the
extended Overspeed mode, stop bits are output at 7/8
the normal width.
Both the SYNC/ASYNC rate converter and the data
descrambler are automatically bypassed in the FSK
modes.
SYNCHRONOUS MODE
Synchronous operation is possible only in the QAM or
DPSK modes. Operation is similar to that of the
Asynchronous mode except that data must be
synchronized to a provided clock and no variation in
data transfer rate is allowable. Serial input data
appearing at TXD must be valid on the rising edge of
TXCLK.
TXCLK is an internally derived 1200 or 2400 Hz signal
in Internal mode and is connected internally to the
RXCLK pin in Slave mode. Receive data at the RXD
pin is clocked out on the falling edge of RXCLK. The
asynch/synch
Synchronous mode is selected and data is transmitted
at the same rate as it is input.
converter
is
bypassed
when
V.22bis/V.22/V.21/Bell 212A/Bell 103
3
PARALLEL BUS INTERFACE
Eight 8-bit registers are provided for control, option
select, and status monitoring. These registers are
addressed
multiplexed address lines (latched by ALE) and
appear to a control microprocessor as seven
consecutive
registers are read/write memory. The detect and
ID registers are read only and cannot be modified
except
parameters.
SERIAL CONTROL MODE
The serial Command mode allows access to the
73K224 control and status registers via a serial
control port. In this mode the AD0, AD1, and AD2
lines provide register addresses for data passed
through AD7 (DATA) pin under control of the RD
and WR lines. A read operation is initiated when
the RD line is taken low. The next eight cycles of
EXCLK will then transfer out eight bits of the
selected address location LSB first. A write takes
place by shifting in eight bits of data LSB first for
eight consecutive cycles of EXCLK. WR is then
pulsed low and data transfer into the selected
register occurs on the rising edge of WR.
DTMF GENERATOR
The DTMF generator controls the sending of the
sixteen standard DTMF tone pairs. The tone pair
sent is determined by selecting TRANSMIT DTMF
(bit D4) and the 4 DTMF bits (D0-D3) of the TONE
register. Transmission of DTMF tones from TXA is
gated by the TRANSMIT ENABLE bit of CR0 (bit
D1) as with all other analog signals.
by
with
modem
memory
Single-Chip Modem
the
response
AD0,
locations.
AD1,
73K224L
to
Six
and
monitored
control
AD2