SSD1805TR1 ETC2 [List of Unclassifed Manufacturers], SSD1805TR1 Datasheet - Page 13

• Manufacturer Part Number: SSD1805TR1
• Description: 132 x 68 STN LCD Segment / Common Monochrome Driver with Controller
• Manufacturer: ETC2 [List of Unclassifed Manufacturers]

6.23 C68/
This pin is MCU parallel interface selection input. When the pin is pulled high, 6800 series interface is
selected and when the pin is pulled low, 8080 series interface is selected. If Serial Interface is selected (
pulled low), the setting of this pin is ignored, but it must be connected to a known logic (either high or low).
6.24 P/
This pin is serial/parallel interface selection input. When this pin is pulled high, parallel interface mode is
selected. When it is pulled low, serial interface will be selected.
Note1: For serial mode,
and C68/80 can be connected to either V
Note2: Read Back operation is only available in parallel mode.
6.25 /HPM
This pin is the control input of High Power Current Mode. The function of this pin is only enabled for High
Power model, which required special ordering. For normal models, High Power Mode is disabled.
Note: This pin must be pulled to high. Leaving this pin floating is prohibited.
6.26 IRS
This is the input pin to enable the internal resistors network for the voltage regulator. When this pin is pulled
high, the internal feedback resistors of the internal regulator for generating V
pulled low, external resistors, R
(see application circuit diagrams).
6.27 C1, C0
These pins are the Chip Mode Selection input. The chip mode is determined by multiplex ratio. Altogether
there are four chip modes. Please see the following list for reference.
C1
0
0
1
1
Please refer to Table 3 on page 15 for detail description of common pins at different multiplex mode.
6.28 B1, B0
These pins are the Chip Mode Selection input. The chip mode is determined by default boosting level.
Altogether there are four chip modes. Please see the following list for reference.
B1
0
0
1
1
5X, 4X, 3X or 2X booster level can be selected as POR default value of the device.
6.29 ROW0 to ROW67
These pins provide the Common driving signals to the LCD panel. See Table 3 on page 15 for the COM
signal mapping in different multiplex mode of SSD1805. There are ICON pins on the chip when either 64 or
54 or 32 Mux mode is selected. The ICON pins are located at the COM 0 pin and COM 67 pin.
6.30 SEG0 to SEG131
These pins provide the LCD segment driving signals. The output voltage level of these pins is V
sleep mode and standby mode.
6.31 TEST0
This pin is a test pin. It is recommended to connect to VSS in normal operation.
SSD1805 Series
C0
0
1
0
1
B0
0
1
0
1
S
80
Chip Mode
32 MUX Mode
54 MUX Mode
64 MUX Mode
68 MUX Mode
Chip Mode
3X as POR default
4X as POR default
5X as POR default
2X as POR default
Rev 1.1
R/W ( WR )
P 13/52
1
and R
Jun 2004
must be connected to Vss. E/(
2
, should be connected to V
DD
or V
SS
.
RD
SS
and V
) must be connected to V
F
, and V
OUT
will be enabled. When it is
F
and V
OUT
Solomon Systech
, respectively
DD
. D0 to D5
SS
during
P/ S