BT8222EPFF CONEXANT [Conexant Systems, Inc], BT8222EPFF Datasheet - Page 98

• Manufacturer Part Number: BT8222EPFF
• Description: ATM Transmitter/Receiver with UTOPIA Interface
• Manufacturer: CONEXANT [Conexant Systems, Inc]

3.0 Registers
3.3 Configuration Control Registers
0x2B—UTOPIA_1 (Utopia Port Control Register 1)
The UTOPIA_1 register is located at address 0x2B and controls operation of the UTOPIA interface. Operation
of the UTOPIA interface is detailed in
3-12
15–7
6
5
4
3, 2
1
0
Bit
9
1
1
1
2
1
1
Field
Size
Reserved
Reset TX FIFO
Reset RX FIFO
Reserved
Flag Threshold
Octet/Cell
Handshake
Enable UTOPIA
Interface
Name
Section
Set to 0.
Resets the address generators and flags associated with the transmit FIFO when
this bit is set high. This bit should be set high when Enable UTOPIA Interface (bit 0)
is first set high, then written low after ATM and PHY layer initialization is complete.
While the CN8223 is being initialized, its bit should be held low. Before setting this
bit high, the ATM layer UTOPIA interface control lines must be in an inactive state. If
they are not, the CN8223 UTOPIA FIFO pointers could become corrupted. To
conserve power, write this bit high if the UTOPIA interface is not used.
Resets the address generators and flags associated with the receive FIFO when this
bit is set high. This bit should be set high when the Enable UTOPIA Interface control
bit is first set high and can then be written low after ATM and PHY layer initialization
is complete. While the CN8223 is being initialized, this bit should be held low.
Before setting this bit high, the ATM layer UTOPIA interface control lines must be in
an inactive state. If they are not, the CN8223 UTOPIA FIFO pointers could become
corrupted. To conserve power, this bit should be written high if the UTOPIA
interface is not used.
Set to 0.
Selects the cell look-ahead level for asserting the TxFull~/TxClav flag to the ATM
layer. The control bits and flag look-ahead are as follows:
Selects the full flag handshake protocol for the FIFO buffers. If this bit is low, then
octet-level handshaking is selected and the flags supplied are TxFull~ and
RxEmpty~. If this bit is high, then cell-level handshaking is selected, and the flags
supplied are TxClav and RxClav. In octet-handshake mode, the RxClav flag goes
active after one full cell is in the receive UTOPIA FIFO. Also in this mode, when the
256-byte transmit UTOPIA FIFO has 252 bytes filled, TxClav goes active, indicating
that only four bytes of space remain.
Selects the interface type on the FIFO I/O pins. If this bit is low, the interface is the
standard four-port FIFO interface. If this bit is high, then the interface is a
single-port UTOPIA-compliant interface controlled by the Port 0 Control Registers.
Handshake Flag Threshold
Octet/Cell
0
1
1
1
2.7.5.
Conexant
01 (Single cell look- ahead)
00 (Two-cell look-ahead)
10 or 11 (Normal mode)
ATM Transmitter/Receiver with UTOPIA Interface
x
Description
Full after current cell + 2 cells
TxFull~/TxClav Look-Ahead
Full after current cell + cell
Full after 4 more octets
Full after current cell
CN8223
100046C