C8051F997-GUR Silicon Labs, C8051F997-GUR Datasheet - Page 66

• Manufacturer Part Number: C8051F997-GUR
• Description: 8-bit Microcontrollers - MCU 8kB 14-CH CDC
• Manufacturer: Silicon Labs

Specifications of C8051F997-GUR

• Rohs: yes
• Core: 8051
• Processor Series: C8051
• Data Bus Width: 8 bit

C8051F99x-C8051F98x
5.2.
ADC0 has a maximum conversion speed of 300 ksps in 10-bit mode. The ADC0 conversion clock
(SARCLK) is a divided version of the system clock when burst mode is disabled (BURSTEN = 0), or a
divided version of the low power oscillator when burst mode is enabled (BURSEN = 1). The clock divide
value is determined by the AD0SC bits in the ADC0CF register.
5.2.1. Starting a Conversion
A conversion can be initiated in one of five ways, depending on the programmed states of the ADC0 Start
of Conversion Mode bits (AD0CM2–0) in register ADC0CN. Conversions may be initiated by one of the
following:
Writing a 1 to AD0BUSY provides software control of ADC0 whereby conversions are performed "on-
demand". During conversion, the AD0BUSY bit is set to logic 1 and reset to logic 0 when the conversion is
complete. The falling edge of AD0BUSY triggers an interrupt (when enabled) and sets the ADC0 interrupt
flag (AD0INT). When polling for ADC conversion completions, the ADC0 interrupt flag (AD0INT) should be
used. Converted data is available in the ADC0 data registers, ADC0H:ADC0L, when bit AD0INT is logic 1.
When Timer 2 or Timer 3 overflows are used as the conversion source, Low Byte overflows are used if
Timer 2/3 is in 8-bit mode; High byte overflows are used if Timer 2/3 is in 16-bit mode. See “25. Timers” on
page 276 for timer configuration.
Important Note About Using CNVSTR: The CNVSTR input pin also functions as Port pin P0.6. When the
CNVSTR input is used as the ADC0 conversion source, Port pin P0.6 should be skipped by the Digital
Crossbar. To configure the Crossbar to skip P0.6, set to 1 Bit 6 in register P0SKIP. See “21. Port
Input/Output” on page 213 for details on Port I/O configuration.
66
Modes of Operation
1. Writing a 1 to the AD0BUSY bit of register ADC0CN
2. A Timer 0 overflow (i.e., timed continuous conversions)
3. A Timer 2 overflow
4. A Timer 3 overflow
5. A rising edge on the CNVSTR input signal (pin P0.6)
Rev. 1.1