P9030-EVK IDT, P9030-EVK Datasheet - Page 12

• Manufacturer Part Number: P9030-EVK
• Description: Power Management IC Development Tools
• Manufacturer: IDT
• Type: PMIC Solutionsr

Specifications of P9030-EVK

• Product: Evaluation Kits
• Tool Is For Evaluation Of: P9030
• Input Voltage: 10 V to 20 V
• Output Voltage: 5 V
• Output Current: 1.5 A
• Part # Aliases: IDTP9030-EVK
• For Use With: P9030-0NTGI

IDTP9030
Product Datasheet
Table 7. IDTP9030 NTG48 Package Pin Functions by Pin Number ()
Note 1:
Note 2: DC-DC BUCK5VT,
thermistor, LED, buzzer and pull up resistor loads (up to an absolute maximum of 25mA), as recommended in Figure 15 WPC “Qi” Compliance Schematic
and Table 6 WPC “Qi” Compliance Bill of Materials.
Revision 1.0.1
PIN
EP
41
42
43
44
45
46
47
48
IN, REG_IN, BUCK5VT_IN. These pins must be connected together at all times.
NAME
Center Exposed
GND
HPF
Pad
NC
NC
NC
NC
NC
NC
LDO2P5V, and LDO5V are intended only as internal device supplies and must not be loaded externally except for the EEPROM,
TYPE
Thermal
-
I
DESCRIPTION
High pass filter input
Internal connection, must be connected to GND.
Ground
Internal connection, must be connected to GND.
Internal connection, must be connected to GND.
Internal connection, must be connected to GND.
Internal connection, must be connected to GND.
Internal connection, do not connect.
EP is on the bottom of the package and must be electrically tied to GND. For thermal
performance, solder to a large copper pad embedded with a pattern of plated through-hole vias.
The die is not electrically bonded to the EP, and the EP must not be used as current-carrying
electrical connection.
12
© 2012 Integrated Device Technology, Inc.