ICB2FL01G Infineon Technologies, ICB2FL01G Datasheet - Page 36

• Manufacturer Part Number: ICB2FL01G
• Description: IC SMART BALLAST CONTROL DSO-19
• Manufacturer: Infineon Technologies
• Type: PFC/Ballast Controllerr

Specifications of ICB2FL01G

• Frequency: 20 ~ 120 kHz
• Current - Supply: 4.2mA
• Voltage - Supply: 10.6 V ~ 17.5 V
• Operating Temperature: -25°C ~ 125°C
• Package / Case: DSO-19
• Packages: PG-DSO-19
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output: -
• Lead Free Status / Rohs Status: Details
• Other names: SP000363741

2.8.3 Built in Customer Test Mode (Clock Acceleration)
The built in customer test mode, supported by this IC, saves testing time for customers in terms of
ballast end test. In that mode, the IC accelerates the internal clock in order to reduce the time of the 4
different procedures by the following factors (see Table 1).
Phase
Preheating
Time Out Ignition
Pre Run Mode
EOL2
Table 1: Specified Acceleration Factors
The clock acceleration (Built in Customer Test Mode) is activated when the chip supply voltage
exceeds V
V
V
powering up. This status is hold as long as the voltage at the RES pin is at V
5 %) – no power up. Note: after the activation of the clock acceleration mode, the voltage level of 5.0V
at the Run Frequency and Preheating Frequency pin (V
In order to start the IC with an accelerated clock, set the voltage at the RES pin to GND (V
Figure 36 “Starting the Chip with an accelerated Clock”. The IC powers up the system and starts
working with an accelerated clock. Now the duration of the different modes are accelerated by Factors
shown in Table 1
Figure 36: Clock Acceleration (Built in Customer Test Mode)
Datasheet
RFRUN
RES
2.8.3.1
2.8.3.2
> 3.5 V up to 5.0 V (± 5 %) prevents a power up of the IC, the IC remains in a mode before
= V
CC
RFPH
> 14.1V and the voltages at the Run Frequency and Preheating Frequency pin are set to
= 5.0 V (± 5 %) see Figure 35 “Enabling of Clock Acceleration”. A RES pin voltage of
Enabling of the Clock Acceleration
Starting the Chip with accelerated Clock
Duration for Test [ms]
2
nd
118.5
41.7
41.7
625
Generation FL-Controller for FL-Ballasts
Page 36 of 56
Acceleration Factor
RFRUN
= V
15
60
4
2
RFPH
) can be released.
Functional Description
Nominal Duration [ms]
RES
> 3.5 V up to 5.0 V (±
2500 (max)
2500
237
625
RES
ICB2FL01G
= 0 V).
V1.2