AFCT-5805DZ Avago Technologies US Inc., AFCT-5805DZ Datasheet - Page 9

• Manufacturer Part Number: AFCT-5805DZ
• Description: TXRX OPT SM 155MBS SONET OC3/SDH
• Manufacturer: Avago Technologies US Inc.

Specifications of AFCT-5805DZ

• Applications: General Purpose
• Data Rate: 155Mbps
• Wavelength: 1300nm
• Voltage - Supply: *
• Connector Type: SC
• Mounting Type: Through Hole
• Data Rate Max: 0.155Gbps
• Supply Voltage: 5V
• Wavelength Typ: 1300nm
• Peak Reflow Compatible (260 C): Yes
• Optical Fiber Type: TX/RX
• Data Transfer Rate: 155Mbps
• Optical Rise Time: 2/2.2ns
• Optical Fall Time: 2/2.2ns
• Operating Temperature Classification: Commercial
• Peak Wavelength: 1360nm
• Operating Supply Voltage (min): 3.1V
• Operating Supply Voltage (typ): 3.3/5V
• Operating Supply Voltage (max): 5.25V
• Operating Temp Range: 0C to 70C
• Mounting: Through Hole
• Pin Count: 9
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Table 2. Pin Out Table
Pin
Mounting Studs
1
2
3
4
5
6
7
8
9
Symbol
V
RD+
RD-
SD
V
V
TD-
TD+
V
EER
CCR
CCT
EET
Functional Description
The mounting studs are provided for transceiver mechanical attachment to the circuit board. They are
embedded in the housing and are not connected to the transceiver internal circuit. They should be
soldered into plated-through holes on the printed circuit board.
Receiver Signal Ground
Directly connect this pin to receiver signal ground plane.
Receiver Data Out
Terminate this high-speed, differential, PECL output with standard PECL techniques at the follow-on
device input pin.
Receiver Data Out Bar
Terminate this high-speed, differential, PECL output with standard PECL techniques at the follow-on
device input pin.
Signal Detect
Normal input optical levels to the receiver result in a logic “1” output.
Low input optical levels to the receiver result in a fault indication shown by a logic “0” output.
Signal Detect is a single-ended, PECL output. This output will operate with 270 Ω termination resistor
to V
This Signal Detect output can be used to drive a PECL input on an upstream circuit, such as, Signal
Detect input and Loss of Signal-bar input.
Receiver Power Supply
Provide +3.3 or +5.0 V dc via the recommended receiver power supply filter circuit.
Locate the power supply filter circuit as close as possible to the V
Transmitter Power Supply
Provide +3.3 or +5.0 V dc via the recommended transmitter power supply filter circuit.
Locate the power supply filter circuit as close as possible to the V
Transmitter Data In Bar
Terminate this high-speed, differential Transmitter Data input with standard PECL techniques at the
transmitter input pin.
Transmitter Data In
Terminate this high-speed, differential Transmitter Data input with standard PECL techniques at the
transmitter input pin.
Transmitter Signal Ground
Directly connect this pin to the transmitter signal ground plane.
EE
to achieve PECL output levels.
CCR
CCT
pin.
pin.