ISL8200MIRZ Intersil, ISL8200MIRZ Datasheet - Page 3

• Manufacturer Part Number: ISL8200MIRZ
• Description: IC BUCK SYNC ADJ 10A 23-QFN
• Manufacturer: Intersil
• Type: Point of Load (POL) Non-Isolatedr

Specifications of ISL8200MIRZ

• Output: 0.6 ~ 6V
• Number Of Outputs: 1
• Power (watts): 60W
• Mounting Type: Surface Mount
• Voltage - Input: 3 ~ 20V
• Package / Case: 23-QFN
• 1st Output: 0.6 ~ 6 VDC @ 10A
• Size / Dimension: 0.59" L x 0.59" W x 0.09" H (15mm x 15mm x 2.2mm)
• Power (watts) - Rated: 60W
• Operating Temperature: -40°C ~ 85°C
• Current - Output: 10A
• Voltage - Output: 0.6 ~ 6 V
• Frequency - Switching: 700kHz ~ 1.5MHz
• Synchronous Rectifier: Yes
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -

Pin Descriptions
Pin Configuration
NUMBER
4, 15
PIN
1
2
3
5
VSEN_REM- Analog Voltage Input - This pin is the negative input of standard unity gain operational amplifier for
PIN NAME
VOUT_SET
ISFETDRV
PGND1
ISET
Analog Voltage Input - Used with V
impedance of VSEN1+ with respect to VSEN1- is 500kΩ. Voltage input typ. 0.6V.
differential remote sense for the regulator, and should connect to the negative rail of the
load/processor. This pin can be used for V
VOUT_SET pin.
Digital Output - This pin is used to drive an optional NFET, which will connect ISHARE with the system
ISHARE bus upon completing a pre-bias startup. Voltage Output Range: 0V to 5V.
Normal Ground - All voltage levels are referenced to this pad.This pad provides a return path for the
low side MOSFET drives and internal power circuitries as well as all analog signals. PGND and PGND1
should be connected together with a ground plane.
Analog Current Output - This pin sources a 15µA offset current plus Channel 1’s average current. The
voltage (VISET) set by an external resistor (RISET) represents the average current level of the local
active module. For full-scale current, RISET should be ~10kΩ. Output current range: 15µA to 108µA
typ.
3
ISL8200M
(32 LD QFN)
ISL8200M
TOP VIEW
OUT
to program the regulator output voltage. The typical input
PIN DESCRIPTION
OUT
trimming by connecting a resistor from this pin to the
February 26, 2010
FN6727.1