STM8/128-MCKIT STMicroelectronics, STM8/128-MCKIT Datasheet - Page 12

• Manufacturer Part Number: STM8/128-MCKIT
• Description: EVAL KIT MOTOR CONTROL STM8S
• Manufacturer: STMicroelectronics
• Series: STM8Sr

Specifications of STM8/128-MCKIT

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: STM8S2xx
• Primary Attributes: Brushless DC (BLDC) & AC Induction (ACIM) Motors
• Secondary Attributes: Joystick & LCD User Interface
• Processor To Be Evaluated: STM8S
• Data Bus Width: 8 bit
• Operating Supply Voltage: 2.95 V to 5.5 V
• Silicon Manufacturer: ST Micro
• Silicon Core Number: STM8
• Features: Motor Control Applications, The Inverter Is Driven Using The Space Vector PWM Modulation Technique
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10032

Hardware layout and configuration
1.13
1.14
1.15
12/41
IrDA
IrDA communication is supported by the IrDA transceiver U14 connected to the UART1 of
STM8S2xx through channel 1 of multiplexer U17. It can be enabled or disabled by setting
JP10:
Table 9.
Development and debug support
The debug connectors available on the STM8/128-EVAL evaluation board are:
●
●
●
Display and input devices
The 122x32 Dot-matrix serial interface LCD (U13) and 4 general purpose LEDs (LD1, 2, 3,
4) are available as display devices. The LCD backlight can be switched ON or OFF by
setting IO PH4. A 4-direction joystick with selection key and general purpose button (B2) are
available as input devices.
Table 10.
JP10
Jumper
CN2, 120-pin SAMTEC connector that supports STice, the advanced emulation system
from STMicroelectronics. The JP1 jumper must connect pin 2 together with pin 3 when
STice is present, as described in
CN4, ERNI 4-pin connector for SWIM debugging
CN17, 2.54mm pitch low-cost 4-pin connector footprint for SWIM debugging (not
populated)
Pin on U13
IrDA related jumpers
LCD modules
1
2
3
4
5
6
7
8
JP10 is used to shut down the IrDA transceiver.
IrDA is enabled when JP10 is fitted, while IrDA is disabled when JP10 is not fitted.
Default status: fitted.
122x32 Dot Matrix LCD U13
Table 2: Reset related
Description
CLK
Vss
Vcc
SID
VO
CS
A
K
Description
jumpers.
To GND through a transistor
Pin connection
GND
PC5
PC6
PF0
+5V
+5V
-
UM0482