STM8/128-MCKIT STMicroelectronics, STM8/128-MCKIT Datasheet - Page 9

• Manufacturer Part Number: STM8/128-MCKIT
• Description: EVAL KIT MOTOR CONTROL STM8S
• Manufacturer: STMicroelectronics
• Series: STM8Sr

Specifications of STM8/128-MCKIT

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: STM8S2xx
• Primary Attributes: Brushless DC (BLDC) & AC Induction (ACIM) Motors
• Secondary Attributes: Joystick & LCD User Interface
• Processor To Be Evaluated: STM8S
• Data Bus Width: 8 bit
• Operating Supply Voltage: 2.95 V to 5.5 V
• Silicon Manufacturer: ST Micro
• Silicon Core Number: STM8
• Features: Motor Control Applications, The Inverter Is Driven Using The Space Vector PWM Modulation Technique
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10032

UM0482
1.5
1.6
1.7
Note:
1.8
I
A 64Kbit I
enabled by setting jumper JP8.
Table 4.
CAN
The STM8/128-EVAL evaluation board supports CAN2.0A/B compliant CAN bus
communication based on 5 V CAN transceiver. The High-speed mode and low-speed mode
are available and can be selected by setting JP6.
Table 5.
RS-232
Two D-type 9-pin connectors CN13 (UART1) and CN15 (UART3) are available on the
STM8/128-EVAL evaluation board. The USART1 connector is connected to channel 3 of the
multiplexer U17, while the USART2 connector is connected to channel 1 of the multiplexer
U18.
UART1 and UART3 are named USART1 and USART2 on the silkscreen (refer to
LIN
Two D-type 9-pin LIN connectors CN11 (LIN1) and CN14 (LIN2) are available on the
STM8/128-EVAL evaluation board. The LIN1 connector is connected to channel 4 of the
multiplexer U17, while the LIN2 connector is connected to channel 0 of the multiplexer U18.
Either master or slave operation mode is supported by both LIN connectors and can be
JP8
JP6
JP7
2
C EEPROM
Jumper
Jumper
2
C EEPROM is connected to the I
I
CAN related jumpers
2
C EEPROM related jumper
I
Default setting: fitted
CAN terminal resistor is enabled when JP7 is fitted.
Default setting: not fitted.
2
C EEPROM U12 is protected from write operations when JP8 is not fitted.
1 2 3
1 2 3
CAN transceiver operates in low-speed mode when JP6 is set as
shown:
CAN transceiver operates in high-speed mode when JP6 is set as
shown:
This is the default setting.
2
C port of STM8S2xx. Write protection can be
Description
Description
Hardware layout and configuration
Figure
9/41
3).