DK-SI-4S100G2N Altera, DK-SI-4S100G2N Datasheet - Page 16

• Manufacturer Part Number: DK-SI-4S100G2N
• Description: KIT DEV STRATIX IV TRANSCEIVER
• Manufacturer: Altera
• Series: Stratix® IVr

Specifications of DK-SI-4S100G2N

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: EP4S100G2F40C2ES1
• Primary Attributes: *
• Secondary Attributes: *
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Stratix
• Silicon Core Number: EP4S
• Silicon Family Name: Stratix IV GT
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2603

6–2
LCD Information
Running the Demonstration Application and Test Designs
Transceiver Signal Integrity Development Kit, Stratix IV GT Edition User Guide
1
1
1
To configure the Stratix IV GT FPGA, perform the following steps:
1. Start the Quartus II Programmer.
2. Click Add File and select the path to the desired .sof.
3. Turn on the Program/Configure option for the added file.
4. Click Start to download the selected file to the FPGA. The FPGA is configured
To determine if the appropriate test design .sof is programmed, check the LCD for the
test design number. Refer to
The LCD shows the following information:
■
■
■
The demonstration application communicates with the set of test designs provided
with the kit. You can change the various transceiver parameters that are described in
this section.
To run the application, make sure that the board is powered up properly and there is a
USB cable attached, then go to the <install
dir>\kits\stratixIVGT_4s100g2_si\demos\ directory and double-click on
stratixIVGT_si_demo.exe file. Ensure that the Stratix IV FPGA is programmed with
the .sof specified in
To enable the application to communicate with the board, click the Connect button. To
close the application, click the Disconnect button
Because the demonstration application communicates with the board using the same
interface as the Quartus II Programmer or SignalTap
you can run only one of these applications at a time.
The application will not run unless the USB cable is attached, power is applied, and
the correct .sof is programmed to the Stratix IV GT FPGA as specified in
page
when the progress bar reaches 100%.
The Stratix IV GT device junction temperature in Celsius.
The power in watts for the different transceivers (VCCA_L/R, VCCT, VCCR,
VCCH_GXB, VCCL_GXB) and core (VCC) voltage supply rails. Turn the rotary
switch SW16 to observe the different voltage supply values.
1
The sof/pof number that is programmed is indicated by ‘pof’ followed by the
number.
6–1.
To learn more about the switch position for displaying the various supply
rail values on the LCD, click the Help button in the demonstration
application.
Table 6–1 on page
“LCD Information”
Chapter 6: Stratix IV GT Transceiver Signal Integrity Demonstration
6–1.
for more information.
(Figure
®
II Embedded Logic Analyzer,
6–1).
© December 2009 Altera Corporation
Table 6–1 on
LCD Information