STEVAL-MKI064V1 STMicroelectronics, STEVAL-MKI064V1 Datasheet - Page 37

• Manufacturer Part Number: STEVAL-MKI064V1
• Description: BOARD ADAPTER LSM303DLH DIL24
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI064V1

• Sensor Type: Accelerometer and Magnetometer
• Sensing Range: ±2g, 4g, 8g, ±1.3 ~ 8.1 gauss
• Interface: I²C
• Sensitivity: 1 ~ 3.9 mg/Digit, ±0.01%/°C
• Embedded: No
• Utilized Ic / Part: LSM303DLH
• Sensing Axis: Double Axis
• Output Type: Digital
• Interface Type: USB
• For Use With: 497-10682 - MOTEHRBOARD MEMS ADAPTER STM32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: LPR5xxxAL, LPY5xxxAL, LY5xxxAL
• Other names: 497-10689

LSM303DLH
9.1.16
The D6 - D0 bits set the minimum duration of the Interrupt 2 event to be recognized.
Duration steps and maximum values depend on the ODR chosen.
INT2_CFG_A (34h)
Table 47.
Table 48.
Configuration register for Interrupt 2 source.
Table 49.
AOI
6D
ZHIE
ZLIE
YHIE
YLIE
XHIE
XLIE
AOI
AOI
0
0
1
1
INT2_CFG_A register
INT2_CFG_A description
Interrupt mode configuration
AND/OR combination of interrupt events. Default value: 0.
(See table below)
6 direction detection function enable. Default value: 0.
(See table below)
Enable interrupt generation on Z high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on Z low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
Enable interrupt generation on Y high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on Y low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
Enable interrupt generation on X high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on X low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
6D
ZHIE
6D
0
1
0
1
Doc ID 16941 Rev 1
ZLIE
YHIE
AND combination of interrupt events
OR combination of interrupt events
6 direction movement recognition
6 direction position recognition
Interrupt mode
YLIE
Registers description
XHIE
XLIE
37/47