AT91SAM9260-EK Atmel, AT91SAM9260-EK Datasheet - Page 38

• Manufacturer Part Number: AT91SAM9260-EK
• Description: KIT EVAL FOR AT91SAM9260
• Manufacturer: Atmel
• Series: AT91SAM Smart ARMr
• Type: MCUr

Specifications of AT91SAM9260-EK

• Contents: Evaluation Board, Parallel Cable and CD-ROM
• Processor To Be Evaluated: AT91SAM9260
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet, USB
• Core: ARM 9
• Silicon Manufacturer: Atmel
• Core Architecture: ARM
• Core Sub-architecture: ARM926EJ-S
• Silicon Core Number: AT91SAM9260
• Silicon Family Name: ARM
• Kit Contents: Board, Cables, CD, Power Supply
• Rohs Compliant: Yes
• For Use With/related Products: AT91SAM9260
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

10.4.7
10.4.8
10.4.9
38
AT91SAM9260
USB Host Port
USB Device Port
Ethernet 10/100 MAC
• Compatibility with SD Memory Card Specification Version 1.1
• Compatibility with SDIO Specification Version V1.0.
• Card clock rate up to Master Clock divided by 2
• Embedded power management to slow down clock rate when not used
• MCI has two slots, each supporting
• Support for stream, block and multi-block data read and write
• Compliance with Open HCI Rev 1.0 Specification
• Compliance with USB V2.0 Full-speed and Low-speed Specification
• Supports both Low-Speed 1.5 Mbps and Full-speed 12 Mbps devices
• Root hub integrated with two downstream USB ports in the 217-LFBGA package
• Two embedded USB transceivers
• Supports power management
• Operates as a master on the Matrix
• USB V2.0 full-speed compliant, 12 MBits per second
• Embedded USB V2.0 full-speed transceiver
• Embedded 2,432-byte dual-port RAM for endpoints
• Suspend/Resume logic
• Ping-pong mode (two memory banks) for isochronous and bulk endpoints
• Six general-purpose endpoints
• Embedded pad pull-up
• Compatibility with IEEE Standard 802.3
• 10 and 100 MBits per second data throughput capability
• Full- and half-duplex operations
• MII or RMII interface to the physical layer
• Register Interface to address, data, status and control registers
• DMA Interface, operating as a master on the Memory Controller
• Interrupt generation to signal receive and transmit completion
• 28-byte transmit and 28-byte receive FIFOs
• Automatic pad and CRC generation on transmitted frames
• Address checking logic to recognize four 48-bit addresses
• Support promiscuous mode where all valid frames are copied to memory
– One slot for one MultiMediaCard bus (up to 30 cards) or
– One SD Memory Card
– Endpoint 0 and 3: 64 bytes, no ping-pong mode
– Endpoint 1 and 2: 64 bytes, ping-pong mode
– Endpoint 4 and 5: 512 bytes, ping-pong mode
6221JS–ATARM–17-Jul-09