101-1274 Rabbit Semiconductor, 101-1274 Datasheet - Page 102

• Manufacturer Part Number: 101-1274
• Description: KIT DEV STANDARD RCM5700
• Manufacturer: Rabbit Semiconductor
• Series: MiniCore™r
• Type: MCUr

Specifications of 101-1274

• Interface Type: Ethernet, SPI
• Operating Temperature Range: - 40 C to + 85 C
• Product: Modules
• Silicon Manufacturer: Rabbit Semiconductor
• Silicon Family Name: RabbitCore
• Kit Contents: Board
• Features: 10/100 Base-T Ethernet, Serial To Ethernet Bridge
• Development Tool Type: Development Kit
• Rohs Compliant: Yes
• For Use With/related Products: RCM5700
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Contents: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 316-1151

F.6 Running Additional Sample Programs With Direct Connect
The sample programs discussed here are in the Dynamic C
PLES\RCM6700\TCPIP
•
•
MiniCore RCM5700/RCM6700 User’s Manual
BROWSELED.C
shown below to run this sample program.
This program demonstrates a basic controller running a Web page. Four “LEDs” are created on
the Web page, and four buttons to toggle them. Users can change the status of the lights from
the Web browser. The LEDs on the Digital I/O accessory board match the ones on the Web
page. As long as you have not modified the
the following server address in your Web browser to bring up the Web page served by the sam-
ple program.
Otherwise use the TCP/IP settings you entered in the
ETHERNET_TO_SERIAL.C
sample program, use the long 10-pin header to DB9 cable
(Part No. 540-0085) to connect header J4 to a PC COM port.
Line up the colored edge of the cable with pin 1 on header J4
as shown in the diagram (pin 1 is indicated by a small square
on the silkscreen). Note that two of the lines in the cable
opposite the colored side are not connected within the 10-pin
connector.
Open a Hyperterminal session (
munications
nected to and set the default serial parameters:
http://10.10.6.100
). Select the PC COM port the cable is con-
—The Digital I/O accessory board must be installed with the jumpers set up as
folder.
—Before you compile and run this
Start > Accessories > Com-
rabbit.com
TCPCONFIG 1
TCP_CONFIG.LIB
SAMPLES\RCM5700\TCPIP\
macro in the sample program, enter
library.
or
SAM-
102