101-1274 Rabbit Semiconductor, 101-1274 Datasheet - Page 15

• Manufacturer Part Number: 101-1274
• Description: KIT DEV STANDARD RCM5700
• Manufacturer: Rabbit Semiconductor
• Series: MiniCore™r
• Type: MCUr

Specifications of 101-1274

• Interface Type: Ethernet, SPI
• Operating Temperature Range: - 40 C to + 85 C
• Product: Modules
• Silicon Manufacturer: Rabbit Semiconductor
• Silicon Family Name: RabbitCore
• Kit Contents: Board
• Features: 10/100 Base-T Ethernet, Serial To Ethernet Bridge
• Development Tool Type: Development Kit
• Rohs Compliant: Yes
• For Use With/related Products: RCM5700
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Contents: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 316-1151

2.2.3 Step 3 — Connect USB Cable
The USB cable connects the RCM5700/RCM6700 to the PC running Dynamic C to download
programs and to monitor the MiniCore module during debugging. It also supplies power to the
Interface Board and the MiniCore via the USB interface.
Connect the USB cable between USB connector J5 on the Interface Board and your PC as shown
in Figure 2-4. Note that the USB cable connectors are different at either end, so there is only one
way to connect them between the PC and the Interface Board.
Your PC should recognize the new USB hardware, and the LEDs next to the USB connector on
the Interface Board will flash — if you get an error message, you will have to install USB drivers.
Drivers for Windows XP are available in the Dynamic C
Cable\WinXP_2K
other operating systems are available online at www.ftdichip.com/Drivers/VCP.htm.
The green power LED on the Interface Board should light up when you connect the USB cable.
The MiniCore and the Interface Board are now ready to be used.
MiniCore RCM5700/RCM6700 User’s Manual
NOTE: A RESET button is provided on the Interface Board above the Ethernet jack to allow a
NOTE: Pins 1–2 on header JP1 on the Interface Board must be jumpered to download and debug
CAUTION: Do not jumper pins 1–3 on header JP1 on the Interface Board.
hardware reset without disconnecting power.
applications and sample programs with Dynamic C running. Pins 1–2 should be left unjumpered
to run an program already loaded in flash memory.
folder — double-click
Figure 2-4. Connect USB Cable
rabbit.com
DPInst.exe
Drivers\Rabbit USB Programming
to install the USB drivers. Drivers for
15