C8051T600DK Silicon Laboratories Inc, C8051T600DK Datasheet - Page 129

• Manufacturer Part Number: C8051T600DK
• Description: KIT DEV FOR C8051T60X MCU'S
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051T600DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051T60x
• Interface Type: USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051T600, C8051T601, C8051T602, C8051T603, C8051T604, C8051T605
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1404

ARBLOST
TXMODE
MASTER
ACKRQ
STO
ACK
STA
Bit
SI

















Table 23.3. Sources for Hardware Changes to SMB0CN
A START is generated.
START is generated.
SMB0DAT is written before the start of an
SMBus frame.
A START followed by an address byte is
received.
A STOP is detected while addressed as a
slave.
Arbitration is lost due to a detected STOP.
A byte has been received and an ACK
response value is needed (only when
hardware ACK is not enabled).
A repeated START is detected as a
MASTER when STA is low (unwanted
repeated START).
SCL is sensed low while attempting to
generate a STOP or repeated START
condition.
SDA is sensed low while transmitting a 1
(excluding ACK bits).
The incoming ACK value is low 
(ACKNOWLEDGE).
A START has been generated.
Lost arbitration.
A byte has been transmitted and an
ACK/NACK received.
A byte has been received.
A START or repeated START followed by a
slave address + R/W has been received.
A STOP has been received.
Set by Hardware When:
Rev. 1.2
C8051T600/1/2/3/4/5/6











A STOP is generated.
Arbitration is lost.
A START is detected.
Arbitration is lost.
SMB0DAT is not written before the
start of an SMBus frame.
Must be cleared by software.
A pending STOP is generated.
After each ACK cycle.
Each time SI is cleared.
The incoming ACK value is high
(NOT ACKNOWLEDGE).
Must be cleared by software.
Cleared by Hardware When:
129