DC-EM-KT Digi International, DC-EM-KT Datasheet - Page 60

• Manufacturer Part Number: DC-EM-KT
• Description: KIT INTEGRATION EM FOR S MODELS
• Manufacturer: Digi International
• Series: Digi Connect EM®r
• Type: MCU Moduler

Specifications of DC-EM-KT

• Contents: Module with plug-and-play firmware, Development Board, Documentation, CD, Cables and Power Supply
• For Use With/related Products: Digi Connect EM S Module
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 602-1003; DC-EM-01T-KT; DC-EM-02T-KT

Radio Frequency Interference (RFI) (FCC 15.105)
Labeling Requirements (FCC 15.19)
Modifications (FCC 15.21)
Cables (FCC 15.27)
6 0
F C C C e r t i f i c a t i o n s f o r D i g i C o n n e c t E S a n d D i g i C o n n e c t R G
This equipment has been tested and found to comply with the limits for Class A digital
devices pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential environment. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try and correct the interference by one or more of the following measures:
This device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Changes or modifications to this equipment not expressly approved by Digi may void the
user's authority to operate this equipment.
Shielded cables must be used to remain within the Class A limitations.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
D i g i C o n n e c t F a m i l y U s e r ’ s G u i d e