C8051F020-TB Silicon Laboratories Inc, C8051F020-TB Datasheet - Page 119

• Manufacturer Part Number: C8051F020-TB
• Description: BOARD PROTOTYPING W/C8051F020
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F020-TB

• Contents: Board
• Processor To Be Evaluated: C8051F02x
• Interface Type: USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F020
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

12.3.5. Interrupt Register Descriptions
The SFRs used to enable the interrupt sources and set their priority level are described below. Refer to the datasheet
section associated with a particular on-chip peripheral for information regarding valid interrupt conditions for the
peripheral and the behavior of its interrupt-pending flag(s).
Bit7:
Bit6:
Bit5:
Bit4:
Bit3:
Bit2:
Bit1:
Bit0:
R/W
EA
Bit7
EA: Enable All Interrupts.
This bit globally enables/disables all interrupts. When set to ‘0’, individual interrupt mask settings are
overridden.
0: Disable all interrupt sources.
1: Enable each interrupt according to its individual mask setting.
IEGF0: General Purpose Flag 0.
This is a general purpose flag for use under software control.
ET2: Enabler Timer 2 Interrupt.
This bit sets the masking of the Timer 2 interrupt.
0: Disable Timer 2 interrupt.
1: Enable interrupt requests generated by the TF2 flag (T2CON.7).
ES0: Enable UART0 Interrupt.
This bit sets the masking of the UART0 interrupt.
0: Disable UART0 interrupt.
1: Enable UART0 interrupt.
ET1: Enable Timer 1 Interrupt.
This bit sets the masking of the Timer 1 interrupt.
0: Disable all Timer 1 interrupt.
1: Enable interrupt requests generated by the TF1 flag (TCON.7).
EX1: Enable External Interrupt 1.
This bit sets the masking of external interrupt 1.
0: Disable external interrupt 1.
1: Enable interrupt requests generated by the /INT1 pin.
ET0: Enable Timer 0 Interrupt.
This bit sets the masking of the Timer 0 interrupt.
0: Disable all Timer 0 interrupt.
1: Enable interrupt requests generated by the TF0 flag (TCON.5).
EX0: Enable External Interrupt 0.
This bit sets the masking of external interrupt 0.
0: Disable external interrupt 0.
1: Enable interrupt requests generated by the /INT0 pin.
IEGF0
R/W
Bit6
ET2
R/W
Bit5
Figure 12.9. IE: Interrupt Enable
ES0
R/W
Bit4
ET1
R/W
Bit3
Rev. 1.4
EX1
R/W
Bit2
C8051F020/1/2/3
ET0
R/W
Bit1
(bit addressable)
EX0
R/W
Bit0
SFR Address:
00000000
Reset Value
0xA8
119