EPSILON5-A1 Equinox Technologies, EPSILON5-A1 Datasheet - Page 16

• Manufacturer Part Number: EPSILON5-A1
• Description: ISP PORTABLE PROGRAMMER USB
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Portable ISPr

Specifications of EPSILON5-A1

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: In-Circuit Programmer
• Features: 2Mbits Of On-Board Non-Volatile FLASH Memory For User Project Storage
• Interface Type: JTAG
• Mcu Supported Families: ATmega And AT91SAM7
• Mpu Supported Families: AVR
• Rohs Compliant: Yes
• External Depth: 31mm
• Height: 189mm
• Length: 80mm
• For Use With/related Products: ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
• Other names: 483-1000

1.5 Programmer Specifications
1.5.1 Programmer Specifications Overview
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
1
2
3
4
5
6
7
8
EPSILON5 MKII Programmer - User Guide V1.12 – 1
Parameter
Target Device
Support
Target Device
Programming
Interfaces
Operating modes
On-board FLASH
Memory Store
Project storage in
Memory Store
Keypad entry
Status LED’s
Target Vcc
Voltage Detection
LED
Description / comment
See Device Support List
The programmer supports the following programming
interfaces:
NXP (Phillips) 8051 - Boot Loader ISP
The programmer supports the following operating modes:
As standard:
Optional chargeable upgrades:
ConsoleEDS PRO – Command Line control
2 Mbits (256 kBytes) FLASH Memory
2 x Push Button - <YES> and <NO>
3 x Status LED’s - <PASS>, <BUSY>, <FAIL>
1 x Programming Project
or 2 x ‘Chained Projects’
•
•
•
•
•
•
•
•
•
•
•
•
•
Atmel Low Voltage SPI
Atmel High Voltage SPI (+12V Vpp)
Atmel AVR JTAG (chargeable update)
Atmel (formerly Temic) 8051 Boot loader ISP
Development Mode (PC controlled)
Project Upload Mode using Upload Wizard (PC
controlled)
Standalone Mode - Keypad + LCD operation
Standalone Mode – Run Target
ConsoleEDS EVAL – Command Line control
Standalone Mode - Remote Controlled via ‘ASCII Text
Communications’ RS-232 Serial Protocol
PC controlled via ISP-PRO software (chargeable
upgrade)
Target Vcc (POWER) LED will light when Target Vcc is
detected.
Threshold detection voltage: approx 3.1V
st
August 2007
Refer
to
section
1.6.1
1.6.2
2.4
5