EPSILON5-A1 Equinox Technologies, EPSILON5-A1 Datasheet - Page 68

• Manufacturer Part Number: EPSILON5-A1
• Description: ISP PORTABLE PROGRAMMER USB
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Portable ISPr

Specifications of EPSILON5-A1

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: In-Circuit Programmer
• Features: 2Mbits Of On-Board Non-Volatile FLASH Memory For User Project Storage
• Interface Type: JTAG
• Mcu Supported Families: ATmega And AT91SAM7
• Mpu Supported Families: AVR
• Rohs Compliant: Yes
• External Depth: 31mm
• Height: 189mm
• Length: 80mm
• For Use With/related Products: ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
• Other names: 483-1000

4.0 ISP Header Selection
4.1 Overview
The EPSILON5 programmer caters for many different connection methods to a Target System by
featuring FOUR possible ISP Header connectors. Each header provides the necessary signals to
program the Target Device plus Vcc (power) and GND (Ground). The choice of which header to use
depends on the ‘device type’ and the algorithm being employed to program the device.
To locate the ISP Headers (J3, J6, J7 & J8), remove the four screws from the back of the programmer
and then carefully remove the lid. If you hold the programmer with the RS-232 connector towards
your, the four ISP headers will be in the positions shown in the figure below. Pin 1 is designated on
each header and should match with the corresponding pin 1 of the cable to be plugged into the
header.
Please see section 4.2 for an overview of each ISP Header.
st
EPSILON5 MKII Programmer - User Guide V1.12 – 1
August 2007
57