EPSILON5-A1 Equinox Technologies, EPSILON5-A1 Datasheet - Page 42

• Manufacturer Part Number: EPSILON5-A1
• Description: ISP PORTABLE PROGRAMMER USB
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Portable ISPr

Specifications of EPSILON5-A1

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: In-Circuit Programmer
• Features: 2Mbits Of On-Board Non-Volatile FLASH Memory For User Project Storage
• Interface Type: JTAG
• Mcu Supported Families: ATmega And AT91SAM7
• Mpu Supported Families: AVR
• Rohs Compliant: Yes
• External Depth: 31mm
• Height: 189mm
• Length: 80mm
• For Use With/related Products: ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
• Other names: 483-1000

2.5.5 Buffer Window - Control Buttons
The Buffer Window within EDS is used as a virtual data store which allows data to be transferred from
file
The ‘Buffer – Control Buttons’ support operations on the data in the Buffer Window including loading a
file into Buffer or saving the contents of the Buffer to file. These buttons do NOT initiate any actual
programming operation of the Target Device.
#
1
2
3
4
5
6
7
EPSILON5 MKII Programmer - User Guide V1.12 – 1
Buffer Window
Button
Re-load File
Edit Buffer
<Load>
<Save as>
<Erase>
<Fill>
Calc CRC
Target Device and vice-versa.
Description / Purpose
It is possible to specify the following properties for the file:
•
•
•
•
•
•
•
•
•
•
•
•
Re-loads the specified HEX / Binary file into the Buffer Window.
Tick the box to enable manual editing of the Buffer Window.
This will also allow the <Load>, <Erase> and <Fill> buttons to be
selected.
This button allows you to manually browse to select a file to be load
into the Buffer Window.
The path will default to the path set up in the Programming Project
(if a file is specified).
This button allows you to save the contents of the Buffer Window to
a file.
File type (HEX / Binary)
File Start and End Address
This button erases the entire contents of the Buffer Window.
All locations are set to the value 0xFF.
This button allows you to fill a specified area of the Buffer Window
with a specified value.
This button calculates the CRC Checksum of the specified range of
the Buffer Window.
st
August 2007
31