EPSILON5-A1 Equinox Technologies, EPSILON5-A1 Datasheet - Page 21

• Manufacturer Part Number: EPSILON5-A1
• Description: ISP PORTABLE PROGRAMMER USB
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Portable ISPr

Specifications of EPSILON5-A1

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: In-Circuit Programmer
• Features: 2Mbits Of On-Board Non-Volatile FLASH Memory For User Project Storage
• Interface Type: JTAG
• Mcu Supported Families: ATmega And AT91SAM7
• Mpu Supported Families: AVR
• Rohs Compliant: Yes
• External Depth: 31mm
• Height: 189mm
• Length: 80mm
• For Use With/related Products: ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
• Other names: 483-1000

1
1.5.4 DC Power Input Connector (CON1)
It is possible to power the programmer from an external power supply by plugging the DC Power
Cable supplied with the programmer into CON1. This connector is a 2.5mm jack socket.
Fig. 1.5.4 CON1 – pin-out
Description
Centre pin
Outer
1.5.5 DC Power Cable Specification
The programmer is supplied with a DC power cable which plugs into CON1. The other end of this
cable is supplied with bare wire ends for connecting to an external power supply. e.g. bench PSU.
Cable Specification:
10
Fig. 1.5.3.2 Programmer – maximum current ratings
#
•
•
•
•
•
Programmer supplying
power to the Target System
Programmer mode
One end features a female 2.5mm DC jack plug
The other end of the cable is supplied with bare wire ends for connecting to an external power
supply. e.g. bench PSU.
The black lead with the white stripe is the +VE cable.
The all black lead is the GROUND cable.
The external voltage applied to CON1 must be between 3.1 and 5.0V !
Voltage
+3.1V to +5.0V from external power supply
0V (Ground connection)
Comments
•
•
EPSILON5 MKII Programmer - User Guide V1.12 – 1
Power is supplied from External
Power Supply via CON1
J9 is fitted connecting the CON1
Vcc to the Target Vcc
Typ
-
Max
300
st
August 2007
Units
mA