190-2255 Bluetechnix, 190-2255 Datasheet - Page 13
![no-image](/images/no-image-200.jpg)
190-2255
Manufacturer Part Number
190-2255
Description
EMULATOR GNICE JTAG UCLINUX
Manufacturer
Bluetechnix
Series
gnICEr
Type
In-Circuit Emulatorr
Datasheet
1.190-2255.pdf
(31 pages)
Specifications of 190-2255
Contents
Emulation Module
For Use With/related Products
Blackfin® Processors
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
190-2253
190-2253
190-2253
4 Development Environment Setup
A serial connection is necessary for communicating with your Bluetechnix Core Module.
Either a USB or a standard RS232 can be used. Please refer to the Bluetechnix Hardware User
Manual for the necessary base board switch settings.
To connect via USB cable, your operating system must have a device driver for the CP2101
USB‐to‐UART converter chip. Most pre‐compiled kernels of Linux distributions have it
already enabled. To verify this, power on your Bluetechnix board and connect to your
machine. A device file
output of the “dmesg” command in a Linux terminal also reports if the device was correctly
detected:
For the connection to the prompts of U‐Boot and uClinux, a terminal program is needed. We
recommend Kermit. It is part of most Linux distributions – the package is usually named
“ckermit”. A quick introduction to terminal programs is given on the web site
http://docs.blackfin.uclinux.org/doku.php?id=terminal_programs&s=kermit
The basic connection parameters for terminal programs are as follows:
If you use Kermit, it is recommended to create the settings file
directory with the following lines:
For fast transfer of files (e.g., uClinux images) to the target hardware via Ethernet, it is
recommended to install a TFTP server on the development workstation. This requires either
a Core Module with on‐board Ethernet capability or a certain Base or Extender board. Please
refer to your Linux distribution’s package database for appropriate TFTP packages. Also,
there is an entry in the Bluetechnix uClinux Wiki about installing a TFTP server:
http://docs.blackfin.uclinux.org/doku.php?id=setting_up_a_tftp_server
Blackfin uClinux User Guide
usb 3-2: configuration #1 chosen from 1 choice
cp2101 3-2:1.0: cp2101 converter detected
usb 3-2: reset full speed USB device using uhci_hcd and address 4
usb 3-2: cp2101 converter now attached to ttyUSB0
Baud rate
Data bits
Stop bits
Flow control
Parity
set line /dev/ttyUSB0
set speed 115200
set carrier-watch off
set flow-control none
set prefixing all
set parity none
set stop-bits 1
set modem none
set file type bin
set file name lit
/dev/ttyUSB0
115200
8
1
none
none
or similar should be automatically generated. The
maximum performance at minimum size
.kermrc
Tinyboards
in your home
Page 13