ST7MDT20-DVP3 STMicroelectronics, ST7MDT20-DVP3 Datasheet - Page 18

• Manufacturer Part Number: ST7MDT20-DVP3
• Description: KIT EMULATOR FOR ST72321/324/521
• Manufacturer: STMicroelectronics
• Series: ST7-DVP3r
• Type: Microcontrollerr

Specifications of ST7MDT20-DVP3

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST72321, ST72324, ST72521
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-4874

Emulation Configuration
4.3.3
Caution:
18/44
1 Ensure that the operating voltage of the ST7-DVP3 emulator (110 Volts/
2 Install the provided ferrite clip on the cord running between the emulator and the
3 Plug the power supply into the mains using the supply cable provided.
Application voltage selector switch
Before you connect your application board to your emulator, you must set the
operating voltage to that which corresponds to the designed operating voltage of
your application board. This is done with the voltage selector switch. The switch is
located on the main emulation board near the status LEDs (see
you to select an operating voltage of either 3.3V or 5V.
Failure to select the correct voltage for your application board can result in damage to your
emulator or your application board.
220 Volts) matches that which is indicated on the label of your power supply.
Contact your dealer if this voltage does not correspond to your mains.
power supply, approximately 10 cm from your emulator (see
3
Figure 9: Connecting the ferrite clip
10 cm
2
1
ST7-DVP3 Emulator User Manual
Power cable
Ferrite
Figure 8
Figure 9
ST7-DVP3 emulator
). It allows
).