HS0005KCU11H Renesas Electronics America, HS0005KCU11H Datasheet - Page 50

• Manufacturer Part Number: HS0005KCU11H
• Description: EMULATOR E10A-USB H8S(X),SH2(A)
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU11H

• Contents: E10A-LITE, Cable and CD-ROM
• Core Architecture: H8S, H8SX And SH2
• Kit Contents: E10A-LITE, Cable And CD-ROM
• Features: H-UDI Interface, 14-Way Cable
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Core Sub-architecture: H8S, H8SX, SH2
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: H8S, H8SX, SH-2, SH-2A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

(1) Open the sliding switch cover and check that the switch (SW1) for setting the emulator is
(2) Select [Renesas] -> [High-performance Embedded Workshop] -> [Setup tool for E10A-USB
Section 3 Preparation before Use
Note: If you are using the HS0005KCU01H (serial No.: 03311C or later) or HS0005KCU02H
Note: When the H8SX device group is used, select [H8SX Device Group].
Rev. 12.00 Aug. 28, 2009 Page 30 of 188
REJ10J1140-1200
3.10.1 Setting up at Purchasing the Emulator or Updating the Version of Software
turned to ‘1’.
Emulator] -> [H8S/xxxx Device Group] from [Programs] in the [Start] menu. A tool for
setting up the emulator is activated.
(serial No.: 04146E or later) emulator hardware, the below procedure may not be required;
follow the procedure only when the dialog box shown in figure 3.13 or 3.14 is displayed
by using the procedure described in section 3.11, System Check.
Figure 3.13 [Emulator firmware error (1)] Dialog Box
Figure 3.14 [Emulator firmware error (2)] Dialog Box