HS0005KCU11H Renesas Electronics America, HS0005KCU11H Datasheet - Page 58

• Manufacturer Part Number: HS0005KCU11H
• Description: EMULATOR E10A-USB H8S(X),SH2(A)
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU11H

• Contents: E10A-LITE, Cable and CD-ROM
• Core Architecture: H8S, H8SX And SH2
• Kit Contents: E10A-LITE, Cable And CD-ROM
• Features: H-UDI Interface, 14-Way Cable
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Core Sub-architecture: H8S, H8SX, SH2
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: H8S, H8SX, SH-2, SH-2A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

Section 3 Preparation before Use
Notes: 1. If the following dialog message is displayed, insert the USB cable again.
Rev. 12.00 Aug. 28, 2009 Page 38 of 188
REJ10J1140-1200
cable while setting up the emulator. The emulator may be
damaged.
3. When using Windows
2. When [Add New Hardware Wizard] is displayed, select the [Search for the best driver
Do not turn off the host computer or disconnect the USB
for your device. (Recommended)] radio button and then the [Specify a location] check
box to select the path to be searched for drivers. The location must be specified as
<Drive>:\DRIVERS. (<Drive> is the CD drive letter.)
The above case only applies when the USB port on the host computer side is changed
and used for first connection. The time may be required until [Add New Hardware
Wizard] is displayed.
displayed to show the disconnection of the USB. However, this is not a problem.
Figure 3.28 [License tool for H8S E10A-USB Emulator] Dialog Box
Figure 3.29 Start of Setting up the Emulator
®
2000, Windows
CAUTION
®
XP, or Windows Vista
®
a dialog box will be