HS0005KCU11H Renesas Electronics America, HS0005KCU11H Datasheet - Page 54

• Manufacturer Part Number: HS0005KCU11H
• Description: EMULATOR E10A-USB H8S(X),SH2(A)
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU11H

• Contents: E10A-LITE, Cable and CD-ROM
• Core Architecture: H8S, H8SX And SH2
• Kit Contents: E10A-LITE, Cable And CD-ROM
• Features: H-UDI Interface, 14-Way Cable
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Core Sub-architecture: H8S, H8SX, SH2
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: H8S, H8SX, SH-2, SH-2A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

(5) When the following dialog box is displayed, setting up the emulator is completed.
(6)
Section 3 Preparation before Use
Notes: 1. Be sure to turn the setup switch (SW1) to ‘1’ except when the setup tool is used.
Rev. 12.00 Aug. 28, 2009 Page 34 of 188
REJ10J1140-1200
When setting up the emulator has been completed, the following message will be displayed.
Turn the setup switch (SW1) to ‘1’, connect the USB cable again, and click the [OK] button.
2. To use the license tool for another device group, it is necessary to set up the firmware
by using the setup tool or license tool that corresponds to the device group. To use the
setup tool, however, the license tool must also be installed. For details on the license
tool, refer to the following section.
Figure 3.23 [Setup Tool for H8S E10A-USB Emulator] Dialog Box
Figure 3.22 Message for Completion of Setting up the Emulator