MPC564EVB Freescale Semiconductor, MPC564EVB Datasheet - Page 44

• Manufacturer Part Number: MPC564EVB
• Description: KIT EVAL FOR MPC561/562/563/564
• Manufacturer: Freescale Semiconductor
• Type: Microcontrollerr

Specifications of MPC564EVB

• Contents: Module Board, Installation Guide, Power Supply, Cable, Software and more
• Processor To Be Evaluated: MPC56x
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet
• For Use With/related Products: MPC561, 562, 563, 564
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

MPC564EVB Jumper and Switch Setup
described in Section 2.2.6, “Connecting the Terminal.”
Once the connection to the PC is made, power may be applied to the PC and the terminal emulation
software can be run. In terminal mode, it is neccessary to select the baud rate and character format
for the channel. The character format should be 8 bits, no parity, one stop bit. (see Section 2.2.5,
“The Terminal Character Format”.) The baud rate should be set to 19200 and XON/XOFF flow
control should be turn on. Power can now be applied to the board.
Pin assignments are as follows.
Pin 1, 4, and 6 = group connected for DTR/DSR flow control null back to host
Pin 2 = TXD output (RS232 level)
Pin 3 = RXD input (RS232 level)
Pin 5 = Ground/Vss/Common
Pin 7 and 8 = group connected for RTS/CTS flow control null back to host
Pin 9 = open
2.3 MPC564EVB Jumper and Switch Setup
Jumper settings are as follows:
Note ‘*’ is used to indicate that default setting.
‘**’ is used to indicate mandatory setting for proper operation.
2-6
JP1
JP2
JP3
BRK_EN
Figure 2-2. Pin assignment for female (Terminal) connector.
Jumper Setting
* 1-2,3-4
1-3,2-4
*1-2 (closest to
RS232
connectors)
2-3
*inserted
Freescale Semiconductor, Inc.
For More Information On This Product,
5
Table 2-2. Jumper Settings
MPC564EVB User’s Manual
9
Go to: www.freescale.com
COM2: TX=Pin3, RX=Pin2 (see silk screen on bottom of
board)
COM2: TX=Pin2, RX=Pin3 (see silk screen on bottom of
board)
Determines the display power pin polarity on the
LCD_PORT. See the schematic
BDM being used runs at 3.3 volts. So the signals need to go
through a level shifter to get 2.6 volts to the part.
BDM being used runs at 2.6 volts.
SWITCH1 will act as a debounced Non-Maskable Interrupt
(ABORT)
6
Function
1