MPC564EVB Freescale Semiconductor, MPC564EVB Datasheet - Page 48
![KIT EVAL FOR MPC561/562/563/564](/photos/39/39/393946/mpc564evbimage_sml.jpg)
MPC564EVB
Manufacturer Part Number
MPC564EVB
Description
KIT EVAL FOR MPC561/562/563/564
Manufacturer
Freescale Semiconductor
Type
Microcontrollerr
Specifications of MPC564EVB
Contents
Module Board, Installation Guide, Power Supply, Cable, Software and more
Processor To Be Evaluated
MPC56x
Data Bus Width
32 bit
Interface Type
RS-232, Ethernet
For Use With/related Products
MPC561, 562, 563, 564
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
1
System Power-up and Initial Operation
RW0, RW2, RW4 – 18, RW23 – 30 provide the user access to external Reset Configuration Word
(RCW) bits not normally required for default MPC564EVB operation. The RW0 – 30 designations
reflect the data bus D0 – D30 bit affected when the RCW word is enabled externally. All RW0 –
30 option bits are defaulted to the logic low value during external RCW word operation. The user
may apply a wire jumper between the 2 pad positions of each RW0 – 30 option to provide a logic
high level on the respective bit position during external RCW operation. Note that the user could
add physical headers (2mm type) to these signals on the board. Refer to the MPC564 user manual
Reset chapter for the respective RCW bit definitions.
2.3.2 Memory Configuration (MAP_SW)
The Memory Configuration switch (MAP_SW) controls the mapping of the MPC564 chip selects
to the different external memories and whether the internal flash is enabled.I
2.4 System Power-up and Initial Operation
When all of the cables are connected to the board, power may be applied. The dBUG ROM Monitor
initializes the board and then displays a power-up message on the terminal.
Part Number: 0xXX
MaskNum: 0xXX
Copyright 1995-2002 Motorola, Inc.
MPC564 MPC564EVB Firmware v3b.1a.xx (Build XXX on XXX
xx:xx:xx)
Enter ’help’ for help.
2-10
Switch
Each Chip Select should only be connected to one device.
1
2
3
4
5
6
7
8
CS3-TA
Name
CS0
CS1
CS0
CS2
CS3
2.6v
IP
1
1
1
1
1
100_CS/LCD_
MPC563/564
Function
RAM_CS
RAM_CS
RCW-IP
FL_CS
FL_CS
FLEN
CS
Freescale Semiconductor, Inc.
TA
For More Information On This Product,
MPC564EVB User’s Manual
TA for LCD or Connect the EtherNet Controller TA to the Pro-
Go to: www.freescale.com
Table 2-4. MAP_SW
CS3 connected to the Ethernet and LCD Interface
All Rights Reserved.
CS0 connected to the External SRAM
CS1 connected to the External SRAM
CS0 connected to the External Flash
CS1 connected to the External Flash
Enable Internal MPC563/564 Flash
Switch Closed
IP bit is set
cessor TA
XX 20XX
Default
off
on
on
off
on
on
on
off