MPC564EVB Freescale Semiconductor, MPC564EVB Datasheet - Page 85

• Manufacturer Part Number: MPC564EVB
• Description: KIT EVAL FOR MPC561/562/563/564
• Manufacturer: Freescale Semiconductor
• Type: Microcontrollerr

Specifications of MPC564EVB

• Contents: Module Board, Installation Guide, Power Supply, Cable, Software and more
• Processor To Be Evaluated: MPC56x
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet
• For Use With/related Products: MPC561, 562, 563, 564
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Freescale Semiconductor, Inc.
Commands
STEP
Step Over
Usage:
STEP
The STEP command can be used to “step over” a subroutine call, rather than tracing every
instruction in the subroutine. The ST command sets a temporary software breakpoint one
instruction beyond the current program counter and then executes the target code. This command
only works when executing code in SRAM.
The STEP command can be used to “step over” BSR and JSR instructions.
The STEP command will work for other instructions as well, but note that if the STEP command
is used with an instruction that will not return, i.e. BRA, then the temporary breakpoint may never
be encountered and dBUG may never regain control.
Examples:
To pass over a subroutine call, the command is:
step
Chapter 3. Using the Monitor/Debug Firmware
3-35
For More Information On This Product,
Go to: www.freescale.com