58545-1 Tyco Electronics, 58545-1 Datasheet - Page 3

• Manufacturer Part Number: 58545-1
• Description: DIE SET UNINSULATED TERMINALS
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper™ III, Solistrand™r

Specifications of 58545-1

• Connector Type: Terminals and Splices
• Crimp Handle: A9996-ND
• Crimp Or Cable Size: 10-22 AWG
• Wire Size (awg): 22-10
• For Use With: SOLISTRAND Uninsulated Terminals And Splices
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: A9813

Rev D
6. To crimp the other half of a splice, reposition the
uncrimped wire barrel in the crimping chamber, and
repeat the crimping procedure.
NOTE
If splice cannot be turned for crimping the other
half, turn the tool around.
2
Splice Wire Barrel
Centered on Anvil of
Lower Die
4
Inspection Hole
3
Brazed Seam
Positioned Toward
Indenter
PRO–CRIMPER II Hand Tool Assembly 58546–1
1
3
Figure 3
Figure 4
CAUTION
1
2
3
4
7. Inspect the crimped splice according to
Figure 4. Check the crimp height as described in
Section 5. If necessary, adjust the shut height as
described in Section 6.
Crimp is centered on wire barrel. It is acceptable for
crimp to be slightly off center, but NOT OFF THE END of
the wire barrel.
Wire size being used matches wire size range stamped
on splice and dies.
Wire insulation does not enter wire barrel.
Wire is flush with or extends slightly beyond end of wire
barrel. Wire is visible through inspection hole of splices.
Damaged splices may not be used. If a damaged
splice is evident, it must be replaced with a new
one.
408–4047
3 of 5