1213563-1 Tyco Electronics, 1213563-1 Datasheet - Page 2

• Manufacturer Part Number: 1213563-1
• Description: TOOL DAHT ADAPTER ASSEMBLY
• Manufacturer: Tyco Electronics

Specifications of 1213563-1

• Connector Type: DAHT Adaptor
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Crimp Handle: -
• Crimp Or Cable Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3. CRIMP HEAD REMOVAL FROM HAND TOOL
Remove the two retaining rings from one side of the
hand tool body and push the retaining pins, along with
the two remaining retaining rings, through the
opposite side of the tool body, as shown in Figure 2.
Slide the crimp head out of the tool body.
4. CRIMP HEAD INSTALLATION INTO ADAPTER
As supplied, the adapter has two quick pins installed.
The pins will be used to secure the crimp head to the
adapter. Therefore, these quick pins must be
removed prior to installing the crimp head; then
proceed as follows:
2
DAHT Adapter Assembly 1213563-1
DANGER
of 5
(Figure 1)
1. Align the crimp head mounting holes with the
adapter quick pin holes as shown in Figure 1; then
insert the crimp head into adapter cavity.
2. Install the quick pins through the slotted holes in
the adapter and into the crimp head mounting
holes. See Figure 1.
NOTE
i
Typical DAHT
Crimp Head
If quick pins become difficult to install, it may be
necessary to jog the clevises to properly align the
holes.
After crimp head is installed, make sure that the
quick pins are FULLY inserted to avoid personal
injury and damage to the tool.
Retaining
Ring(s)
Tyco Electronics Corporation
Retaining
Pin(s)
Figure 2
5. ADAPTER INSTALLATION AND REMOVAL
After the crimp head has been installed onto the
adapter, the adapter is ready for installation onto the
pneumatic tool. Refer to Customer Manual 409–5862
for instructions on removing previously installed cam
and tool holder from pneumatic tool. Locate the
adapter cam (supplied with the adapter assembly),
then proceed as follows:
CAUTION
DANGER
DANGER
1. If cam setscrew is not installed in cam, thread
setscrew into cam two to three turns.
2. Place cam (with setscrew) onto power unit
piston rod, as shown in Figure 3. Cam should butt
against the piston rod face. If not, turn cam
setscrew counterclockwise until cam fits on piston
rod properly.
Typical DAHT
Handle Assembly
!
Air pressure must be removed from the unit while
head or tool holder is detached.
DO NOT operate pneumatic tool without the
proper adapter and crimp head installed.
Over-tightening the cam setscrew may damage
the setscrew or cam.
Retaining
Ring(s)
(Figure 3)
408-4485
Rev
A