68081 Tyco Electronics, 68081 Datasheet - Page 4

• Manufacturer Part Number: 68081
• Description: PNEU HEAD COPALUM 8-1/0AWG
• Manufacturer: Tyco Electronics

Specifications of 68081

• Lead Free Status / RoHS Status: Not applicable / Not applicable

4 of 8
Insulation Piercing COPALUM Terminal and Splice Crimping Heads
NOTE
5. To crimp other half of butt splice, remove and
rotate splice 180 end over end. Reposition
uncrimped half in lower jaw as described in step
(1). If splice cannot be rotated, rotate tool. Insert
wire and then crimp the splice.
6. Refer to Section 3 and Figure 5 for crimp
inspection.
Wire Range
Stamped on Bottom
of Tongue
i
Butt splices may be slightly bent when crimped
as instructed in step (4). If this bending is
objectionable, use the following crimping
procedure:
Wire Range
Stamped Here
ACCEPT
Tyco Electronics Corporation
Parallel Splice
Butt Splice
Figure 5
Terminal
C. Parallel Splices
Ensure that wire size stamped on the splice
corresponds with the wire size stamped on the
crimping head link.
1. Position splice between locators as shown in
Figure 4C.
2. Insert wires into splice until ends of wires are
flush with or extended slightly beyond wire barrel.
Hold splice in place, press thumb control and hold
it down until crimping stroke is completed.
Wire Range
Stamped Here
Wire Range
Stamped
on Bottom
of Tongue
REJECT
408-2433
Rev A