S1D15206F00A200 Epson, S1D15206F00A200 Datasheet - Page 310

• Manufacturer Part Number: S1D15206F00A200
• Description: LCD Drivers LCD DRIVER
• Manufacturer: Epson

Specifications of S1D15206F00A200

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

• Static Indicator Register Set
This command sets two bits of data into the static indicator register, and is used to set the static indicator into a blinking
mode.
• Static Indicator Register Set Sequence
(20) Power Save (Compound Command)
When the display all points ON is performed while the display is in the OFF mode, the power saver mode is entered,
thus greatly reducing power consumption.
The power saver mode has two different modes: the sleep mode and the standby mode. When the static indicator is OFF,
it is the sleep mode that is entered. When the static indicator is ON, it is the standby mode that is entered.
In the sleep mode and in the standby mode, the display data is saved as is the operating mode that was in effect before
the power saver mode was initiated, and the MPU is still able to access the display data RAM.
Refer to figure 28 for power save off sequence.
Rev. 2.4a
A0 RD WR D7 D6 D5 D4 D3 D2 D1 D0
0
E R/W
1
0
Power save OFF (compound command)
*
Display all points OFF command
*
*
Static indicator OFF
(2 bytes command)
Sleep mode cancel
Static indicator ON
Sleep mode
*
*
Power saver (compound command)
*
No
0
0
1
1
Static indicator register set
Static indicator mode set
0
1
0
1
Changes complete?
Figure 27
Figure 28
EPSON
OFF
ON (blinking at approximately one second intervals)
ON (blinking at approximately 0.5 second intervals)
ON (constantly on)
Yes
(Display all points OFF command)
Static indicator
mode clear
Standby mode cancel
Static indicator ON
Power save OFF
Indicator Display State
Standby mode
S1D15605 Series
* Disabled bit
8–55