FW82801EB S L73Z Intel, FW82801EB S L73Z Datasheet - Page 575

• Manufacturer Part Number: FW82801EB S L73Z
• Manufacturer: Intel

Specifications of FW82801EB S L73Z

• Lead Free Status / RoHS Status: Not Compliant

16.2.8
Intel
®
82801EB ICH5 / 82801ER ICH5R Datasheet
Note: Reads across DWord boundaries are not supported.
GLOB_CNT—Global Control Register
(Modem—D31:F6)
I/O Address:
Default Value:
Lockable:
31:6
Bit
6
5
4
3
2
1
0
Reserved.
AC_SDIN2 Interrupt Enable (S2RE) — R/W.
0 = Disable
1 = Enable an interrupt to occur when the codec on the AC_SDIN2 causes a resume event on the
AC_SDIN1 Resume Interrupt Enable (S1RE) — R/W.
0 = Disable
1 = Enable an interrupt to occur when the codec on the AC_SDIN1 causes a resume event on the
AC_SDIN0 Resume Interrupt Enable (S0RE) — R/W.
0 = Disable
1 = Enable an interrupt to occur when the codec on AC_SDIN0 causes a resume event on the AC-
ACLINK Shut Off (LSO) — R/W.
0 = Normal operation.
1 = Controller disables all outputs which will be pulled low by internal pull down resistors.
AC ’97 Warm Reset — R/W (special).
0 = Normal operation.
1 = Writing a 1 to this bit causes a warm reset to occur on the AC-link. The warm reset will awaken
AC ’97 Cold Reset# — R/W.
0 = Writing a 0 to this bit causes a cold reset to occur throughout the AC ‘97 circuitry. All data in
1 = This bit defaults to 0 and hence after reset, the driver needs to set this bit to a 1. The value of
Note: This bit is in the Core well.
GPI Interrupt Enable (GIE) — R/W. This bit controls whether the change in status of any GPI
causes an interrupt.
0 = Bit 0 of the Global Status Register is set, but no interrupt is generated.
1 = The change on value of a GPI causes an interrupt and sets bit 0 of the Global Status Register.
AC-link.
AC-link.
link.
a suspended codec without clearing its internal registers. If software attempts to perform a
warm reset while AC_BIT_CLK is running, the write will be ignored and the bit will not change.
This bit is self-clearing (it remains set until the reset completes and AC_BIT_CLK is seen on
the AC-link, after which it clears itself).
the controller and the codec will be lost. Software needs to clear this bit no sooner than the
minimum number of ms have elapsed.
this bit is retained after suspends; hence, if this bit is set to a 1 prior to suspending, a cold reset
is not generated automatically upon resuming.
MBAR + 3Ch
00000000h
No
AC ’97 Modem Controller Registers (D31:F6)
Description
Attribute:
Size:
Power Well:
R/W, R/W (special)
32 bits
Core
575