MC9S08GB60ACFUE Freescale, MC9S08GB60ACFUE Datasheet - Page 45

• Manufacturer Part Number: MC9S08GB60ACFUE
• Manufacturer: Freescale

Specifications of MC9S08GB60ACFUE

• Cpu Family: HCS08
• Device Core Size: 8b
• Frequency (max): 40MHz
• Interface Type: I2C/SCI/SPI
• Total Internal Ram Size: 4KB
• # I/os (max): 56
• Number Of Timers - General Purpose: 8
• Operating Supply Voltage (typ): 2.5/3.3V
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 1.8/2.08V
• On-chip Adc: 8-chx10-bit
• Instruction Set Architecture: CISC
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 64
• Package Type: LQFP
• Program Memory Type: Flash
• Program Memory Size: 60KB
• Lead Free Status / RoHS Status: Compliant

4.2
The registers in the MC9S08GBxxA/GTxxA are divided into these three groups:
Direct-page registers can be accessed with efficient direct addressing mode instructions. Bit manipulation
instructions can be used to access any bit in any direct-page register.
user-accessible direct-page registers and control bits.
The direct page registers in
requires the lower byte of the address. Because of this, the lower byte of the address in column one is
shown in bold text. In
Table
from the bit names to the right. Cells that are not associated with named bits are shaded. A shaded cell with
a 0 indicates this unused bit always reads as a 0. Shaded cells with dashes indicate unused or reserved bit
locations that could read as 1s or 0s.
Freescale Semiconductor
•
•
•
4-2,
Direct-page registers are located in the first 128 locations in the memory map, so they are
accessible with efficient direct addressing mode instructions.
High-page registers are used much less often, so they are located above 0x1800 in the memory
map. This leaves more room in the direct page for more frequently used registers and variables.
The nonvolatile register area consists of a block of 16 locations in flash memory at
0xFFB0–0xFFBF.
Nonvolatile register locations include:
— Three values which are loaded into working registers at reset
— An 8-byte backdoor comparison key which optionally allows a user to gain controlled access
Because the nonvolatile register locations are flash memory, they must be erased and programmed
like other flash memory locations.
Register Addresses and Bit Assignments
Table
to secure memory
4-3, and
Table 4-3
Table
Table 4-2
4-4, the register names in column two are shown in bold to set them apart
and
Table 4-4
MC9S08GB60A Data Sheet, Rev. 2
can use the more efficient direct addressing mode which only
the whole address in column one is shown in bold. In
Table 4-2
is a summary of all
Chapter 4 Memory
45