LMX2541SQE3320E/NOPB National Semiconductor, LMX2541SQE3320E/NOPB Datasheet - Page 12

• Manufacturer Part Number: LMX2541SQE3320E/NOPB
• Description: IC PLL FREQ SYNTH W/VCO 36LLP
• Manufacturer: National Semiconductor
• Series: PowerWise®r
• Type: Clock/Frequency Synthesizer (RF)r

Specifications of LMX2541SQE3320E/NOPB

• Pll: Yes
• Input: Clock
• Output: Clock
• Number Of Circuits: 1
• Ratio - Input:output: 2:2
• Differential - Input:output: No/No
• Frequency - Max: 3.6GHz
• Divider/multiplier: Yes/No
• Voltage - Supply: 3.15 V ~ 3.45 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 36-LLP
• Frequency-max: 3.6GHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: LMX2541SQE3320ETR

Typical Performance Characteristics (Not Guaranteed)
LMX2541SQ3740E Raw Phase Noise Measurement
30073307
The above plot demonstrates the PLL phase noise of the LMX2541SQ3700E operating at 3700 MHz output frequency, phase detector frequency of 100 MHz,
and charge pump gain of 32X. The loop bandwidth was made as wide as possible to fully expose the PLL phase noise and reference source was a 100 MHz
Wenzel crystal. This measurement was done in integer mode. To better understand the impact of using fractional mode, consult the applications section.
The measured noise is the sum of the PLL 1/f noise and noise floor. At offsets below 1 kHz, the PLL 1/f noise dominates and changes at a rate of 10 dB/decade.
The noise at 1 kHz is dominated by this 1/f noise and has a value of -103 dBc/Hz. In the 100 - 200 kHz offset range, the noise is -113.7 dBc/Hz and is dominated
by the PLL noise floor. It can be shown that if the effects of the loop filter peaking and the 1/f noise are subtracted away from this measurement, it would be about
0.6 dB better.
If the phase detector frequency is changed with the VCO frequency held constant, the PLL noise floor will change, but the 1/f noise will remain the same. If the
VCO frequency is changed, both the 1/f noise and PLL noise floor change at a rate of 20 dB/decade.
LMX2541SQ2690 System Phase Noise
30073327
For this plot, a third order modulator with dithering disabled was used with a fractional denominator of 500000. The charge pump gain was 32X and the loop filter
components were C1 = 2.2 nF, C2 = 22 nF, R2 = 470 Ω. The internal loop filter components were C3_LF = 20 pF, C4_LF = 100 pF, R3_LF = 1 kΩ, R4_LF = 200
Ω. The VCO frequency is 2720.1 MHz. The OSCin signal was a 500 MHz differential LVPECL output of the LMK04033.
www.national.com
12