PEB24911HV13 Lantiq, PEB24911HV13 Datasheet - Page 111

• Manufacturer Part Number: PEB24911HV13
• Manufacturer: Lantiq

Specifications of PEB24911HV13

• Lead Free Status / Rohs Status: Supplier Unconfirmed

• MON-0 RCC requests the NT to send corrupt CRCs. Again the CRC will be
• MON-0 NCC requests the NT to disable the NEBE-detection. However, the NCC
Auto-modeNEBE-detection stopped, no MON-1 NEBE
messages and NEBE-counter disabled
Transparent modeNEBE-detection enabled, MON-1-message NEBE
issued and NEBE-counter enabled
• MON-8 SFB causes the DFE-Q V2.1 to invert single FEBE-bits. Because this
• MON-0 RTN and MON-8 NORM disable again activated test functions
Data Sheet
permanently inverted. After issuing RCC (NT in EOC automode) near-end block errors
will be registered on the LT-side.
command shows only effect if the NT U-transceiver operates in EOC automode. The
different behavior of the NT U-transceiver is summarized below
command does not provoke permanent FEBE-bit inversion but sets only one FEBE-
bit to (0) per SFB command it is possible to predict exactly the FEBE-counter value.
101
Operational Description
PEF 24911
2001-07-16