AT86RF232 Atmel Corporation, AT86RF232 Datasheet - Page 51

• Manufacturer Part Number: AT86RF232
• Manufacturer: Atmel Corporation

Specifications of AT86RF232

• Max. Operating Frequency: 0 MHz
• Crypto Engine: AES
• Operating Voltage (vcc): 1.8 to 3.6
• Frequency Band: 2.4 GHz
• Max Data Rate (mb/s): 0.25
• Antenna Diversity: Yes
• External Pa Control: Yes
• Power Output (dbm): 3
• Receiver Sensitivity (dbm): -100
• Receive Current Consumption (ma): 11.8
• Transmit Current Consumption (ma): 13.8
• Link Budget (dbm): 103

8321A–MCU Wireless–10/11
PAN-Coordinator
Table 7-7
Table 7-7. Configuration of a PAN Coordinator.
Promiscuous Mode
The promiscuous mode is described in IEEE 802.15.4-2006, Section 7.5.6.5. This mode
is further illustrated in
promiscuous mode, the MAC sub layer shall pass received frames with correct FCS to
the next higher layer and shall not process them further. That implies that frames
should never be acknowledged.
Only second level filter rules as defined by IEEE 802.15.4-2006, Section 7.5.6.2, are
applied to the received frame.
0x20,0x21
0x22,0x23
Register
Address
0x0C
0x2C
0x2B
0x2E
0x2E
0x2E
0x24
…
shows the Atmel AT86RF232 RX_AACK configuration for a PAN coordinator.
Register
Bits
7:6
7
0
3
5
Register Name
SHORT_ADDR_0/1
PAN_ADDR_0/1
IEEE_ADDR_0
…
IEEE_ADDR_7
RX_SAFE_MODE
SLOTTED_OPERATION
AACK_I_AM_COORD
AACK_SET_PD
AACK_FVN_MODE
Figure
7-11. According to IEEE 802.15.4-2006 when in
Description
Set node addresses.
0: Disable frame protection.
1: Enable frame protection.
0: Slotted acknowledgment transmissions
are not to be used.
1: Slotted acknowledgment transmissions
are to be used.
1: Device is PAN coordinator.
0: Frame pending subfield is not set in
FCF.
1: Frame pending subfield is set in FCF.
Controls the ACK behavior, depends on
FCF frame version number.
0x00: Acknowledges only frames with
version number 0, that is according to
IEEE 802.15.4-2003 frames.
0x01: Acknowledges only frames with
version number 0 or 1, that is frames
according to IEEE 802.15.4-2006.
0x10: Acknowledges only frames with
version number 0 or 1 or 2.
0x11: Acknowledges all frames,
independent of the FCF frame version
number.
AT86RF232
51