ACS8525 Semtech Corporation, ACS8525 Datasheet - Page 89

• Manufacturer Part Number: ACS8525
• Description: Line Card Protection Switch For Sonet/sdh Systems
• Manufacturer: Semtech Corporation

Address (hex):
Address (hex):
Revision 3.00/October 2003 © Semtech Corp.
ADVANCED COMMUNICATIONS
Register Name
fine_limit_en
Register Name
coarse_lim_
phaseloss_en
Bit No.
Bit No.
Bit 7
[4:3]
[2:0]
Bit 7
5
7
73 (cont...)
74
cnfg_phase_loss_fine_limit
noact_ph_loss
Description
narrow_en (test control bit)
Set to 1 (default value).
Not used.
phase_loss_fine_limit
When enabled by Bit 7, this register coarsely sets
the phase limit at which the device indicates phase
lost or locked. The default value of 2 (010) gives a
window size of around ±90 - 180º. The phase
position of the inputs to the DPLL has to be within
the window limit for 1 – 2 seconds before the device
indicates phase lock. If it is outside the window for
any time then phase loss is immediately indicated.
For most cases the default value of 2 (010) is
satisfactory. The window size changes in proportion
to the value, so a value of 1 (001) will give a narrow
phase acceptance or lock window of approximately
±45 - 90º.
cnfg_phase_loss_coarse_limit
wide_range_en multi_ph_resp
Description
coarse_lim_phaseloss_en
Register bit to enable the coarse phase detector,
whose range is determined by
phase_loss_coarse_limit Bits [3:0]. This register
sets the limit in the number of input clock cycles (UI)
that the input phase can move by before the DPLL
indicates phase lost.
Bit 6
Bit 6
narrow_en
Bit 5
Bit 5
Description
Description
Bit 4
Bit 4
FINAL
Page 89
(R/W) Register to configure some
of the parameters of the DPLL
phase detectors.
(R/W) Register to configure some
of the parameters of DPLL phase
detectors.
Bit Value
Bit Value
Bit 3
Bit 3
000
001
010
011
100
101
110
111
0
1
0
1
-
Value Description
Set to 1.
-
Do not use. Indicates phase loss continuously.
Small phase window for phase lock indication.
Recommended value.
)
)
) Larger phase window for phase lock indication.
)
)
Value Description
Phase loss not triggered by the coarse phase lock
detector.
Phase loss triggered when phase error exceeds the
limit programmed in phase_loss_coarse_limit,
Bits [3:0].
phase_loss_coarse_limit
Bit 2
Bit 2
phase_loss_fine_limit
Default Value
Default Value
ACS8525 LC/P
Bit 1
Bit 1
DATASHEET
www.semtech.com
1010 0010
1000 0101
Bit 0
Bit 0