sc16c2552b NXP Semiconductors, sc16c2552b Datasheet - Page 14

• Manufacturer Part Number: sc16c2552b
• Description: Sc16c2552b 5 V, 3.3 V And 2.5 V Dual Uart, 5 Mbit/s Max. , With 16-byte Fifos
• Manufacturer: NXP Semiconductors

Philips Semiconductors
9397 750 14442
Product data
7.2.1 IER versus Transmit/Receive FIFO interrupt mode operation
7.2.2 IER versus Receive/Transmit FIFO polled mode operation
Table 7:
When the receive FIFO (FCR[0] = logic 1), and receive interrupts (IER[0] = logic 1)
are enabled, the receive interrupts and register status will reflect the following:
When FCR[0] = logic 1, resetting IER[0-3] enables the SC16C2552B in the FIFO
polled mode of operation. In this mode, interrupts are not generated and the user
must poll the LSR register for TX and/or RX data status. Since the receiver and
transmitter have separate bits in the LSR either or both can be used in the polled
mode by selecting respective transmit or receive control bit(s).
Bit
0
•
•
•
•
•
•
•
•
•
The receive RXRDY interrupt (Level 2 ISR interrupt) is issued to the external CPU
when the receive FIFO has reached the programmed trigger level. It will be cleared
when the receive FIFO drops below the programmed trigger level.
Receive FIFO status will also be reflected in the user accessible ISR register when
the receive FIFO trigger level is reached. Both the ISR register receive status bit
and the interrupt will be cleared when the FIFO drops below the trigger level.
The receive data ready bit (LSR[0]) is set as soon as a character is transferred
from the shift register (RSR) to the receive FIFO. It is reset when the FIFO is
empty.
When the Transmit FIFO and interrupts are enabled, an interrupt is generated
when the transmit FIFO is empty due to the unloading of the data by the TSR and
UART for transmission via the transmission media. The interrupt is cleared either
by reading the ISR register, or by loading the THR with new data characters.
LSR[0] will be a logic 1 as long as there is one byte in the receive FIFO.
LSR[1-4] will provide the type of receive errors, or a receive break, if encountered.
LSR[5] will indicate when the transmit FIFO is empty.
LSR[6] will indicate when both the transmit FIFO and transmit shift register are
empty.
LSR[7] will show if any FIFO data errors occurred.
Interrupt Enable Register bits description
Symbol
IER[0]
5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 16-byte FIFOs
Rev. 02 — 13 December 2004
Description
Receive Holding Register. In the 16C450 mode, this interrupt will
be issued when the RHR has data, or is cleared when the RHR is
empty. In the FIFO mode, this interrupt will be issued when the
FIFO has reached the programmed trigger level or is cleared when
the FIFO drops below the trigger level.
Logic 0 = Disable the receiver ready (ISR level 2, RXRDY)
interrupt (normal default condition).
Logic 1 = Enable the RXRDY (ISR level 2) interrupt.
…continued
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
SC16C2552B
14 of 37