sc16c2552b NXP Semiconductors, sc16c2552b Datasheet - Page 5

• Manufacturer Part Number: sc16c2552b
• Description: Sc16c2552b 5 V, 3.3 V And 2.5 V Dual Uart, 5 Mbit/s Max. , With 16-byte Fifos
• Manufacturer: NXP Semiconductors

Philips Semiconductors
Table 2:
9397 750 14442
Product data
Symbol
CTSA, CTSB
DSRA, DSRB 41, 29
DTRA, DTRB
RIA, RIB
RTSA, RTSB
RXA, RXB
TXA, TXB
Pin description
Pin
40, 28
37, 27
43, 31
36, 23
39, 25
38, 26
Type
I
I
O
I
O
I
O
…continued
Description
Clear to Send (Active-LOW). These inputs are associated with individual UART
channels, A through B. A logic 0 on the CTS pin indicates the modem or data set is
ready to accept transmit data from the SC16C2552B. Status can be tested by reading
MSR[4].
Data Set Ready (Active-LOW). These inputs are associated with individual UART
channels, A through B. A logic 0 on this pin indicates the modem or data set is
powered-on and is ready for data exchange with the UART.
Data Terminal Ready (Active-LOW). These outputs are associated with individual
UART channels, A through B. A logic 0 on this pin indicates that the SC16C2552B is
powered-on and ready. This pin can be controlled via the modem control register.
Writing a logic 1 to MCR[0] will set the DTR output to logic 0, enabling the modem. This
pin will be a logic 1 after writing a logic 0 to MCR[0], or after a reset.
Ring Indicator (Active-LOW). These inputs are associated with individual UART
channels, A through B. A logic 0 on this pin indicates the modem has received a ringing
signal from the telephone line. A logic 1 transition on this input pin will generate an
interrupt if modem status interrupt is enabled.
Request to Send (Active-LOW). These outputs are associated with individual UART
channels, A through B. A logic 0 on the RTS pin indicates the transmitter is ready to
transmit data. Writing a logic 1 in the modem control register MCR[1] will set this pin to
a logic 0, indicating that the transmitter is ready to transmit data. After a reset this pin
will be set to a logic 1.
Receive data A, B. These inputs are associated with individual serial channel data to
the SC16C2552B receive input circuits, A-B. The RX signal will be a logic 1 during
reset, idle (no data). During the local loop-back mode, the RX input pin is disabled and
TX data is connected to the UART RX input, internally.
Transmit data A, B. These outputs are associated with individual serial transmit
channel data from the SC16C2552B. The TX signal will be a logic 1 during reset, idle
(no data), or when the transmitter is disabled. During the local loop-back mode, the TX
output pin is disabled and TX data is internally connected to the UART RX input.
5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 16-byte FIFOs
Rev. 02 — 13 December 2004
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
SC16C2552B
5 of 37