MC908MR8MPE Freescale Semiconductor, MC908MR8MPE Datasheet - Page 257

• Manufacturer Part Number: MC908MR8MPE
• Description: IC MCU 8BIT 8K FLASH 28-PDIP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908MR8MPE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SCI
• Peripherals: LVD, POR, PWM
• Number Of I /o: 12
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 28-DIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

13.4.3.1 Character Length
13.4.3.2 Character Reception
13.4.3.3 Data Sampling
MC68HC908MR8 — Rev 4.1
Freescale Semiconductor
The receiver can accommodate either 8-bit or 9-bit data. The state of the
M bit in SCI control register 1 (SCC1) determines character length.
When receiving 9-bit data, bit R8 in SCI control register 2 (SCC2) is the
ninth bit (bit 8). When receiving 8-bit data, bit R8 is a copy of the eighth
bit (bit 7).
During an SCI reception, the receive shift register shifts characters in
from the PTB0/RxD pin. The SCI data register (SCDR) is the read-only
buffer between the internal data bus and the receive shift register.
After a complete character shifts into the receive shift register, the data
portion of the character transfers to the SCDR. The SCI receiver full bit,
SCRF, in SCI status register 1 (SCS1) becomes set, indicating that the
received byte can be read. If the SCI receive interrupt enable bit, SCRIE,
in SCC2 is also set, the SCRF bit generates a receiver CPU interrupt
request.
The receiver samples the PTB0/RxD pin at the RT clock rate. The RT
clock is an internal signal with a frequency 16 times the baud rate. To
adjust for baud rate mismatch, the RT clock is resynchronized at these
times (see
To locate the start bit, data recovery logic does an asynchronous search
for a logic 0 preceded by three logic 1s. When the falling edge of a
possible start bit occurs, the RT clock begins to count to 16.
•
•
After every start bit
After the receiver detects a data bit change from logic 1 to logic 0
(after the majority of data bit samples at RT8, RT9, and RT10
return a valid logic 1 and the majority of the next RT8, RT9, and
RT10 samples return a valid logic 0)
Serial Communications Interface (SCI)
Figure
13-6):
Serial Communications Interface (SCI)
Functional Description
Technical Data
257