HD64F2338VFC25 Renesas Electronics America, HD64F2338VFC25 Datasheet - Page 843

• Manufacturer Part Number: HD64F2338VFC25
• Description: MCU 3V 256K 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2338VFC25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 106
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

On-Chip RAM Area Divisions in Boot Mode: In boot mode, the 2-kbyte area from H'FFDC00
to H'FFE3FF is reserved for use by the boot program, as shown in figure 19.39. The area to which
the programming control program is transferred is H'FFE400 to H'FFFBFF. The boot program
area can be used when the programming control program transferred into RAM enters the
execution state. A stack area should be set up as required.
Notes on Use of Boot Mode
• When the chip comes out of reset in boot mode, it measures the low-level period of the input at
• In boot mode, if any data has been programmed into the flash memory (if all data is not 1), all
• Interrupts cannot be used while the flash memory is being programmed or erased.
• The RxD1 and TxD1 pins should be pulled up on the board.
the SCI’s RxD1 pin. The reset should end with RxD1 high. After the reset ends, it takes
approximately 100 states before the chip is ready to measure the low-level period of the RxD1
pin.
flash memory blocks are erased. Boot mode is for use when user program mode is unavailable,
such as the first time on-board programming is performed, or if the program activated in user
program mode is accidentally erased.
Note: * The boot program area cannot be used until a transition is made to the execution state
for the programming control program transferred to RAM. Note that the boot program
remains stored in this area after a branch is made to the programming control program.
Figure 19.39 RAM Areas in Boot Mode
H'FFDC00
H'FFE3FF
H'FFFBFF
control program
Boot program
Programming
(2 kbytes)
(6 kbytes)
area*
area
Rev.4.00 Sep. 07, 2007 Page 811 of 1210
REJ09B0245-0400