UPD78F9200MA-CAC-A Renesas Electronics America, UPD78F9200MA-CAC-A Datasheet - Page 258

• Manufacturer Part Number: UPD78F9200MA-CAC-A
• Description: MCU 8BIT 1KB FLASH 128B RAM
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9200MA-CAC-A

• Package / Case: *
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Speed: 10MHz
• Number Of I /o: 7
• Core Processor: 78K0S
• Program Memory Type: FLASH
• Ram Size: 128 x 8
• Program Memory Size: 1KB (1K x 8)
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Peripherals: LVD, POR, PWM, WDT
• Core Size: 8-Bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Connectivity: -

16.8.8 Example of byte write operation in self programming mode
256
An example of the byte write operation in self programming mode is explained below.
<1> Set 05H (byte write) to the flash program command register (FLCMD).
<2> Set the number of block to which data is to be written, to flash address pointer H (FLAPH).
<3> Set the address at which data is to be written, to flash address pointer L (FLAPL).
<4> Set the data to be written, to the flash write buffer register (FLW).
<5> Clear the flash status register (PFS).
<6> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)
<7> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the
<8> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS.
<9> Byte write processing is abnormally terminated.
<10> Byte write processing is normally terminated.
Note This setting is not required when the watchdog timer is not used.
Caution If a write results in failure, erase the block once and write to it again.
HALT instruction if self programming has been executed.)
Abnormal → <9>
Normal
→ <10>
CHAPTER 16 FLASH MEMORY
User’s Manual U18172EJ3V0UD
Note
.