XR16L788CQ-F Exar Corporation, XR16L788CQ-F Datasheet - Page 14

• Manufacturer Part Number: XR16L788CQ-F
• Description: IC UART 64B 3.3V OCTAL 100QFP
• Manufacturer: Exar Corporation
• Type: IrDA or RS- 485r

Specifications of XR16L788CQ-F

• Number Of Channels: 8
• Package / Case: 100-BQFP
• Features: *
• Fifo's: 64 Byte
• Protocol: RS485
• Voltage - Supply: 2.97 V ~ 5.5 V
• With Auto Flow Control: Yes
• With Irda Encoder/decoder: Yes
• With False Start Bit Detection: Yes
• With Modem Control: Yes
• Mounting Type: Surface Mount
• Data Rate: 6.25 Mbps
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 2.97 V
• Supply Current: 5 mA
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Operating Supply Voltage: 3.3 V or 5 V
• No. Of Channels: 8
• Uart Features: Tx/Rx FIFO Counters
• Supply Voltage Range: 2.97V To 5.5V
• Operating Temperature Range: 0°C To +70°C
• Digital Ic Case Style: QFP
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 1016-1283

XR16L788
HIGH PERFORMANCE 2.97V TO 5.5V OCTAL UART
For Trigger Table D (or programmable trigger levels), the RTS# output pin is de-asserted when the the RX
FIFO level reaches the RX trigger level plus the hysteresis level and is asserted when the RX FIFO level falls
below the RX trigger level minus the hysteresis level.
However, even under these conditions, the 788 will continue to accept data until the receive FIFO is full if the
remote UART transmitter continues to send data.
•
Automatic CTS/DSR flow control is used to prevent data overrun to the remote receiver FIFO. The CTS/DSR
pin is monitored to suspend/restart local transmitter. The flow control features are individually selected to fit
specific application requirement (see
•
•
With the Auto CTS or Auto DTR function enabled, the UART will suspend transmission as soon as the stop bit
of the character in the Transmit Shift Register has been shifted out. Transmission is resumed after the CTS#/
DTR# input is re-asserted (logic 0), indicating more data may be sent.
•
2.10.1
If used, enable RTS/DTR interrupt through IER bit-6 (after setting EFR bit-4). The UART issues an interrupt
when the RTS#/DTR# pin makes a transition: ISR bit-5 will be set to 1.
Select CTS (and RTS) or DSR (and DTR) through MCR bit-2.
Enable auto CTS/DSR flow control using EFR bit-7.
If used, enable CTS/DSR interrupt through IER bit-7 (after setting EFR bit-4). The UART issues an interrupt
when the CTS#/DSR# pin makes a transition: ISR bit-5 will be set to a logic 1, and UART will suspend TX
transmissions as soon as the stop bit of the character in process is shifted out. Transmission is resumed
after the CTS#/DSR# input returns LOW, indicating more data may be sent.
Auto CTS/DSR Flow Control
Figure
10):
14
REV. 1.2.3