ATAKSTK511-8 Atmel, ATAKSTK511-8 Datasheet - Page 18

• Manufacturer Part Number: ATAKSTK511-8
• Description: KIT RF MODULE 868MHZ FOR STK500
• Manufacturer: Atmel
• Series: SmartRF®r
• Type: Transmitter, Receiver, ASK, FSKr

Specifications of ATAKSTK511-8

• Frequency: 868MHz
• Wireless Frequency: 868 MHz
• For Use With/related Products: ATSTK500
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

1925C–AVR–3/03
Hardware Description
3.7
3-8
Target Socket
Section
The programming module consists of the eight sockets in the white area in the middle of
the starter kit. In these sockets, the target AVR devices can be inserted for programming
and are used in the application.
Note:
The AVR Flash memory is guaranteed to be correct after 1,000 programming opera-
tions; the typical lifetime of the Flash memory is much longer.
Note:
The notch on the short side of the part must match the notch on the socket. If the device
is inserted the wrong way, it may damage the part and the starter kit.
The socket section is used for both running applications and target device programming.
Figure 3-15. The STK500 Programming Module
The part inserted in the socket can be programmed in the system from AVR Studio with
two different methods:
1. AVR In-System Programming (ISP) running at the parts normal supply voltage.
2. High-voltage Programming, where the supply voltage is always 5 volts.
Four general nets (VTARGET, RESET, XTAL1 and AREF) can be connected to the
socket section.
The following sections describe how to use both programming methods. For instructions
on using the AVR Studio programming software, see Section 5, “Using AVR Studio” on
page 5-1.
Only one AVR device should be inserted in the sockets at a time.
When inserting a device in the socket, notice the orientation of the device.
AVR STK500 User Guide